Rectifier Functions - Kripsol KLS 20 Manual De Instrucciones

6. RECTIFIER FUNCTIONS

The KRIPSOL chlorinator is equipped with a sophisticated electronic
diagnosis system, which maximises the life of the electrolytic cell and
incorporates an easy-to-read display, 4 LED indicators and an alarm
signal, indicating the action to take whenever necessary.
The screens are summarised below, with an indication of the action to
take in each case:
SCREEN No. 1
FUNCTIONING
INDICATOR
1
The unit starts up immediately when it is turned on. If there is a lack
of water flow the LED comes on and the fault is shown on the display.
Otherwise, the unit operates normally. Press button no. 2 (+) if you want to
increase chlorine production. Press button no. 1 (-) if you want to reduce
chlorine production. Each time these buttons are pressed the percentage
production changes by 10%.
If the salt levels are incorrect (too much or too little) the corresponding
LED will light up and the relevant message will appear on the display. The
fault LED will also be lit up together with any of these illuminated warnings.
SCREEN No. 2
To move to the second screen press buttons 1 and 2 (-) and (+)
simultaneously to display the following screen.
The right of the screen shows the times at which the unit is scheduled
to reverse polarity. The options the unit offers are:
•Every 2 / 6 / 8 / 12 hours
% CHLORINE
PRODUCTION
25 25
2
UNIT STATUS
LEDS