Troubleshooting - Kripsol KLS 20 Manual De Instrucciones

In the equipment of 50-100g to return to the home screen should make
4 simultaneous keystrokes on (+) (-) Visualizing in each of the steps the
following pictures:
Screens are NO configuration step. In the equipment 20-30 gr is only
necessary to perform a single-click simultaneously (+) (-) to return to the
Home screen

7. TROUBLESHOOTING

1. No current:
▪ Check that the unit is plugged in.
2. Low reading on the chlorine meter:
▪ Insufficient salt in the swimming pool.
▪ Electrodes need cleaning.
▪ Electrodes worn.
3. Residual chlorine in the pool is low:
▪ Chlorinator is not running long enough.
▪ The chlorine stabiliser level is low.
▪ The electrodes need cleaning.
▪ The pH is too high.
Note: If a low chlorine level is detected, the chlorinator can be checked
quickly by taking a water sample from the skimmer and checking the
chlorine level with the analysis kit. Then take a sample directly from one
of the outlets. The chlorine level at the outlet should be significantly higher
than that of the skimmer (at least 1%).
If the residual chlorine in the swimming pool is low, please check if:
a. The chlorinator is not running for a sufficient length of time.
b. The chlorine stabiliser level is low.
c. The cell needs cleaning.
d. The pH is high.
e. The salt level is low.
IMPORTANT NOTE
27 27