ETI Solid State Lighting RK-72-850-MV-D Guía De Uso Y Cuidado página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

installation - Other Fixtures (continued)
4
wiring the Shunted Sockets
□ Push the solid copper jumper wires (AA and BB) into the holes on the shunted
sockets (C).
□ Add sockets depending on the type of connection mode.
C
AA or BB
L
N
BB
Connection Modes
1 Tube Installation with
2 Tube Parallel
Ballast Removed
Installation with Ballast
Removed
L
N
L
LED lamp
LED lamp
LED lamp
5
Replacing Sockets
□ Remove current sockets.
□ Insert the wired shunted sockets (C) into the existing fixture brackets to
replace the previous sockets.
C
AA or BB
L
N
BB
3 Tube Parallel
4 Tube Parallel
Installation with Ballast
Installation with Ballast
Removed
Removed
N
L
N
L
LED lamp
LED lamp
LED lamp
LED lamp
LED lamp
LED lamp
LED lamp
C
10
installation - Other Fixtures (continued)
6
Connecting to the Power Source
CaUTiOn: Make sure the sockets on one end of the tube are wired for hot or live current (L) and the sockets on the other end of the tube
are wired for neutral (N). If installing mulitple LED tubes in the fixture, the sockets at each end of the tubes should all match live current (L)
or match neutral (N).
□ Insert the hot/live (black) wire from the electrical box and the remaining open end of the hot/live (black) solid copper jumper wire
(AA) from the wired sockets (C) into a wire connector (EE).
□ Insert the neutral (white) wire from the electrical box and the remaining open end of the neutral (white) solid copper jumper wire
(AA) from the wired sockets (C) into a wire connector (EE).
□ Replace the ballast cover, if necessary.
nOTe: Insert the ground wire from
the electrical box and the ground wire
from the light fixture into the third
remaining wire connector (EE).
N
7
Installing LED Tubes
□ Insert the end of the LED tube (A) labeled "L" into the wired socket with the
hot/live (black) wire connected.
□ Turn the tube a quarter turn to lock it in place.
□ Affix the UL Safety Sticker (DD) in a visible location.
CaUTiOn: If installing more than one LED tube in the fixture, make
certain that all hot/live (L) connections are made at the same end of the
side-by-side tubes (A).
8
Attaching the fixture lens
□ Reattach the lens to the fixture.
□ Make sure the lens is secure.
C
AA
AA
AA
EE
EE
C
9
□ Restore power at the electrical panel.
□ Turn on the light switch to activate
11
Please contact 1-855-384-7754 or further assistance.
C
AA
A
DD
AA
Restoring Power
the fixture.
www.ETiSSL.CoM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rk-72-840-mv-d

Tabla de contenido