4. Bath Only Installations
NOTE: Bath only installations require two-valve yokes.
NOTE: Typical dimensions for bath and shower installations are
shown on the rough-in diagram.
NOTE: Refer to the trim installation instructions for specific
requirements.
Unless otherwise instructed, rough-in the supply yoke 2-1/4" (57
mm) minimum to 3" (76 mm) maximum from the centerline of
the yoke to the outside of the finished wall.
Install 1/2" hot and cold supply tubing.
If specified, install the screwdriver stop valves.
NOTE: Three-valve yokes have no embossed graphics for the
showerhead and spout locations.
Using a 3/8" hex wrench, remove the aspirator from the yoke and
discard.
Install a plug in the showerhead pipe opening.
Warranty
KOHLER
Faucet Lifetime Limited Warranty
®
Kohler Co. warrants its Faucets* manufactured after January 1, 1997, to
be leak and drip free during normal residential use for as long as the
original consumer purchaser owns his or her home. If the Faucet
Kohler Co.
Plug
4"
(102 mm)
Temporary
Nipple
7
1205552-2-A