Kenmore 795.7414 Manual De Uso Y Cuidado página 44

TROUBLESHOOTING GUIDE
COOLING
Problem
Refrigerator or Refrigerator was recently installed.
freezer section is too
•
warm.
The air vents are blocked. Cold air circulates from the freezer to the fresh food section and
back again through air vents in the wall dividing the two sections.
•
Doors are opened often or for long periods of time.
•
Unit is installed in a hot location.
•
A large amount of food or hot food was added to either compartment.
•
Doors are not closed correctly.
•
Temperature control is not set correctly.
•
Defrost cycle has recently completed.
•
It may take up to 24 hours for each compartment to reach the desired temperature.
Locate air vents by using your hand to sense airflow and move all packages that
block vents and restrict airflow. Rearrange items to allow air to flow throughout the
compartment.
When the doors are opened often or for long periods of time, warm, humid air enters the
compartment. This raises the temperature and moisture level within the compartment. To
lessen the effect, reduce the frequency and duration of door openings.
The refrigerator should not be operated in temperatures above 110 °F (43 °C).
Adding food warms the compartment requiring the cooling system to run. Allowing hot
food to cool to room temperature before putting it in the refrigerator will reduce this
effect.
See the "Doors will not close correctly or pop open" section in the Troubleshooting.
If the temperature is too warm, adjust the control one increment at a time and wait for the
temperature to stabilize.
During the defrost cycle, the temperature of each compartment may rise slightly and
condensation may form on the back wall. Wait 30 minutes and confirm the proper
temperature has been restored once the defrost cycle has completed.
Possible Cause & Solution
44