Honeywell QuickSTEAM HWM-330 El Manual Del Propietario página 9

QuickSteam_OM_04-25-06.qxd
Digital EasySet ™ Control Operation (Model HWM-450) cont'd.
• Press the Timer button (
would like the humidifier to run (Fig. 17).
• When the display indicates your desired time, wait 3 seconds.
• After 3 seconds, your desired time is set and the display will revert
back to showing the current room humidity.
NOTE: If you wish to change your Timer setting or check to see how
much time is left simply press the Timer button once and it will show
you the time left. If you want to change the time remaining, continue to
push the button up or down until you have reached your desired time.
Again, after 3 seconds the display will revert to showing the current
room humidity.
S T E P 4 : S E T H U M I D I T Y
• You can set your desired humidity in 1% increments anywhere from
25% to 65%.
• To set your desired humidity, press the Humidity button (
or down (Fig. 18).
• When the display indicates your desired humidity setting wait
3 seconds.
• After 3 seconds your desired humidity is set and the display will
revert back to showing the current room humidity.
NOTE: If you wish to change your Humidity setting or check to see what
you set, simply press the Humidity button once and it will show you the
set humidity. If you want to change it, continue to push the button up
or down until you have reached your new desired humidity. Again, after
3 seconds the display will revert to showing the current room humidity.
• Once you have set your humidity the unit will operate under this
desired setting until the unit is turned off.
• When your desired room humidity has been reached your unit will
shut off and the House Icon ( ) on the top of your display will
illuminate (Fig. 19). It will stay illuminated until your desired humidity
decreases at which time your unit will turn back on.
NOTE: Your room humidity can often fluctuate. It is normal for your
unit to turn itself on and off throughout the day as it is monitoring
your changing environment.
R E F I L L / C L E A N I N D I C A T O R
• When the Refill/Clean indicator light is illuminated it implies your unit
is out of water or you need to clean your humidifier.
• Check your water level. If your Tank is empty, remove the Tank and
refill it as described in the FILLING section.
• Press the Reset button to restart the humidifier after the Tank is reinstalled (Fig. 20).
• The humidifier will then resume to its previous settings.
• If your water level is full, this implies it's time to clean your humidifier. Please turn off and
unplug the unit and refer to the CLEANING section.
NOTE: Do not press the Reset button until the Tank has been refilled and reinstalled.
NOTE: Your unit's performance will decrease if you do not clean your heating plate. Your unit may
continuously shut off and output will decrease.
4/25/06 4:53 PM
) up or down to set how many hours you
Page 9
Fig. 17
Fig. 18
) up
Fig. 19
Fig. 20
9