Microphone Mixing; Setting The Time - Panasonic SC-AK331 Instrucciones De Funcionamiento

H.BASS
MIC VOL
MIC
Microphone
(not included)
[, REC
SLEEP
SHIFT
Cassettes
Recording
To stop recording
Press [L, STOP].
If the tape finishes before the disc
The disc continues playing. Press [L, STOP] to stop it.
Note
•
Changes to volume and sound/field quality do not affect recording.
•
You cannot open deck 1 while recording.
•
You cannot fast-forward or rewind one deck while recording with
the other.
•
When recording an AM broadcast, sound is momentarily interrupted
when you start and stop the recording.
Erasure prevention
Use a screwdriver or
similar object to break
out the tab.
To re-record on a protected cassette
Cover the hole with adhesive tape.
To erase a tape
1. Disconnect the microphone.
2. Press [;:, TAPE] and then [L, STOP].
3. Insert the recorded tape into deck 2.
Ensure there is no tape in deck 1.
4. Press and hold [PLAY MODE] on the remote control to select
reverse mode.
5. Press [[, REC].
12
RQT7799
L, STOP
; :, TAPE
VOLUME
r
PLAY/REC
CLOCK/TIMER
g
, REW/3,
f
, 4/FF
H.BASS H.BASS
PRESET EQ
Side A
Tab for side A
Tab for side B
Adhesive
tape

Microphone mixing

Enjoying the microphone mixing
You can enjoy mircophone mixing with audio sources (tape/disc/radio/
aux).
1
First, lower volume with [MIC VOL], then connect the
microphone (not included).
Plug type: 3.5 mm monaural
2
Start the source (CD, etc.).
3
Adjust volume with [VOLUME] and [MIC VOL] and sing
along.
Note
•
If strange noise (squealing or howling) is emitted during use, move
the microphone further away from the speakers, or turn down the
microphone volume.
•
When you are not using the microphone, disconnect it from the MIC
jack, and turn down the microphone volume level to MIN.
•
Sound quality can be adjusted when using microphone mixing but
recording will not be affected.
Microphone mixing recording
Preparations:
•
Do steps 1 and 2 on page 11: "Recording".
•
Do step 1 on above "Enjoying the microphone mixing".
•
When singing along with disc
Insert the desired discs (A page 6).
•
When singing along with tape
Insert the desired tape into deck 1 (A page 11).
•
When singing along with radio
Select your desired station (A page 10).
•
When singing along from an external source
Connect and prepare the source (A page 14).
Press [a, REC] and start microphone mixing.
To stop recording
Press [L, STOP].
To record your voice
Preparation: Do steps 1 and 2 on page 11: "Recording".
Ensure there is no tape in deck 1.
1. First, lower volume with [MIC VOL], then connect the microphone.
2. Press [a, REC] to start recording.
3. Speak through the microphone and adjust volume with [VOLUME]
and [MIC VOL].

Setting the time

Remote control only
PL
: This is a 12-hour clock.
GCP
: This is a 24-hour clock.
1
Switch on the power.
2
Press [SHIFT] + [CLOCK/TIMER] to select "CLOCK".
Every time you press the button:
CLOCK PLAY REC
Previous dispaly
3
(Within 7 seconds or so)
Press [g, REW/3] or [f, 4/FF] to set the time.
4
Press [SHIFT] + [CLOCK/TIMER] to finish setting the
time.
The display will return to whatever was displayed before you set
the time.
To display the time
Press [SHIFT] + [CLOCK/TIMER] once when the unit is on or at
standby mode.
The time is shown for about 5 seconds.
Note
Reset the clock regularly to maintain accuracy.