Troubleshooting; Protect The Environment - Black and Decker ASI200 Manual De Instrucciones

Troubleshooting

PROBLEM POSSIBLE CAUSE
Inflator will 12 Volt adaptor
not operate not connected
Accessory socket
not live
No preset
valve set
The fuse in the
12 Volt adaptor
is blown
Cord or switch is
damaged.
Replacing the fuse in the vehicle dc
accessory plug
• Remove the cap by turning it counter-
clockwise.
• Loosen the cap and centre pin.
• Remove the fuse.
• Fit a new fuse of the same type and size
(8A/250V).
• Refit the cap and centre pin.
• Tighten the cap by turning clockwise onto
the plug.

Protect the environment

Separate collection. This product
must no be disposed of with normal
household waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
household waste. Make this product available for
separate collection.
Separate collection of used products and
packaging allows materials to be recycled
and used again. Re-use of recycled
materials helps prevent environmental
pollution and reduces the demand for raw
materials.
Local regulations may provide for separate
collection of electrical products from the
POSSIBLE SOLUTION
household, at municipal waste sites or by the
Connect the 12 Volt retailer when you purchase a new product.
adaptor
Batteries
Turn key to accessory
position
Set preset value
Replace the fuse with
one of the same size
and type (8A/250V)
Have the cord or
switch replaced at a
Black & Decker Service
Centre or Authorized
Service Centre.
At the end of their useful life, discard
batteries with due care for our
environment:
• Do not short-circuit the battery terminals.
• Do not dispose of the battery(s) in a fire as
this may result in a risk of personal injury or
an explosion.
• Run the battery down completely, then
remove it from the tool.
• Batteries are recyclable. Place the battery(s)
in a suitable packaging to ensure that the
terminals cannot be short-circuited. Take
them to any authorised repair agent or a
local recycling station.
Technical Data
Input voltage
Input current
Pressure (max)
Weight
ASI200
Vdc 12
A 8
kPa / psi / bar 827 / 120 / 8.27
kg 1.12
15