Fault-Finding Chart - SFA Sanipack Manual De Instalación

8490 NOTICE SANIPACK-SANINSIDE N¡126:5926 NOTICE N¡125
SANIPACK /SANINSIDE
®
8
STANDARDS
9
COMMISSIONING THE UNIT
SANIPACK
WARNING:
SANIPACK
1 0
USAGE AND WARNING
SANIPACK /SANINSIDE
®
IT IS NOT SUITABLE FOR HEAVY
COMMERCIAL/INDUSTRIAL APPLICATIONS.
WARNING: SANIPACK
Do not use SANIPACK
®
discharging at more than 15 litres per minute.
If away for a prolonged time eg. holiday, we would
recommend that you turn off the water supply to the
WC connected to the unit.
WARNING: The SANIPACK
used for the evacuation of normal human waste, toilet
paper and household WC cleansers.
Damage may occur to the machine if the following are
disposed of in the WC: Cotton wool, tampons, sanitary
towels, condoms, wet wipes, kitchen towels as well as
other fabric or hard items.
A build-up of hair can cause problems, so a hair trap
should be fitted to a shower.
Finally, solvents, acids and other chemicals can also
damage the unit, and will invalidate the warranty.
1 1
CARE OF YOUR SANIPACK
SANIPACK /SANINSIDE
®
®
/SANINSIDE
® ®
/SANINSIDE
® ®
SANIPACK /SANINSIDE
®
®
/SANINSIDE
® ®
/SANINSIDE with a shower
®
/SANINSIDE should only be
® ®
® /SANINSIDE ®
®
11/05/12 11:44 Page 9
1 2

FAULT-FINDING CHART

For the most part, any inconsistencies in the
operation of the unit will be minor and easily rectified. Please
refer to the chart below. If the problem cannot easily be
remedied in this way, please call our Service Organisation.
Warning - Always disconnect the electricity supply before attempting any
SYMPTOM
• The unit stops.
• The motor intermittently
activates.
• The water in the WC pan
goes down very slowly.
• The motor operates
normally, but continues
to run for a long time.
• The motor does not
®
activate.
• The motor emits a rattling
or crunching sound.
• The motor hums, but
does not turn.
• Cloudy water comes up
into the shower basin
(units with side inlets).
REMOVING THE SANIPACK
THE WC SUITE
1 3
Any replacement of the power supply cable should only be carried
Disconnect the electrical power
out by an authorised SANIFLO service engineer.
supply.
A
B
C
D
E
F
Note:
SANINSIDE
®
Do not reconnect the electrical supply until
the re-installation of the unit is complete.
1 4
GUARANTEE
SANIPACK /SANINSIDE
®
9
work on the SANIFLO
®
PROBABLE CAUSES REMEDIES
• An object is blocking the • Ask an approved repair
blades. agent to intervene.
• The unit has been
running for too long.
• The WC cistern or taps are • Check the installation
running/leaking. upstream.
• The external non-return • Clean or replace the
valve is faulty. non-return valve.
• The inner grille (4) is • Call a service engineer to
clogged. clear the grille.
• The air inlet is clogged • Clear the air inlet.
up.
• The length or height of • Check the installation.
the installation is over
specification, or there are
too many bends/elbows. • Call a service engineer to
• The pump itself is unblock the unit.
blocked.
• The electrical supply is • Restore the electrical
switched off. supply.
• The electrical supply is • Call a service engineer to
faulty. inspect the motor.
• The motor is defective. • Call a service engineer to
inspect the motor.
• A foreign object has • Call a service engineer to
entered into the grille via remove the foreign object
the WC pan. from the unit.
• The capacitor or motor is • Call a service engineer to
defective. inspect the motor.
• Shower installed too low • Check the installation
as compared with the
macerator unit
• Hinged side inlet discs • Call a service engineer to
clogged up remove the foreign
object.
/SANINSIDE
® ®
SANIPACK
®
FROM
/
®