Stroller Wheels - BOB IRONMAN DUALLIE Guia Del Usuario

BOB Gear by Britax

Stroller Wheels

Rear Wheel Installation
1� Unlock Parking Brake
Prior to installing the rear wheels,
position the parking brake in the
unlocked position.
2� Insert Rear Wheel Stub Axle
Insert the rear wheel's stub axle
into the hole in the rear dropout
until a "click" is heard.
IMPORTANT: If no click is heard,
the wheel may not be secure in
the attachment bracket and may
detach during operation. Pull on
wheel to ensure proper installation�
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
6
2� Remove Wheel
Raise the wheel a few inches off
the ground and pull the wheel out
of the dropout.
Front Wheel Installation
1� Remove Quick Release Axle
From Front Wheel
Unscrew the nut from the quick
release axle and remove the axle
from the front wheel.
NOTE: Prior to installing the front
wheel, it is necessary to open the
brake release to provide clearance
for the wheel/tire to pass the
brake pads.
2� Open Brake Quick Release
Open the brake release by
rotating the brake release lever in
the clockwise direction.
Brake Quick
OPEN
Release
IRONMAN DUALLIE/S.U.S. DUALLIE User Guide
3� Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with the holes in the fork blades.
4� Insert Quick Release Axle
Insert the quick release axle into
the fork and through the wheel
hub, then install the tension
adjusting nut to the opposite side.
5� Tighten Tension Adjusting Nut
With the quick release lever in
the FULLY OPEN position, hand
tighten the tension adjusting nut
until secure.
Tension Adjusting Nut
6� Close Quick Release Lever
Lift up on the quick release lever
to lock into the FULLY CLOSED
position. When properly closed,
the quick release lever will be
parallel to the fork blade and
pointing up.
FULLY CLOSED
Fork Blade
FULLY OPEN
IMPORTANT: It takes
considerable force to securely
close the quick release lever. If
you are able to completely close
the quick release lever without
wrapping your fingers around the
fork blade and the quick release
lever does not leave a visible
imprint in the palm of your hand,
or the quick release lever spins
freely on the quick release axle,
the tension is not adequate.
Return the lever to the FULLY
OPEN position and turn the
tension adjusting nut a quarter
turn clockwise, then repeat the
closing process.
If the quick release lever will
not lift into the FULLY CLOSED
position, return the lever to the
FULLY OPEN position and turn
the tension adjusting nut a quarter
turn counterclockwise. Repeat
the closing process.
7� Close Brake Quick Release
After installing the front wheel,
the brake release will need to be
placed in the closed position.
Close the brake release lever by
squeezing the brake pads toward
the wheel with either hand then
rotate the brake release lever with
your other hand, in the counter
clockwise direction, until it points
downward.
Brake Quick Release
CLOSED
7