Checking Tire Pressure; Adjusting The Tracking - BOB IRONMAN DUALLIE Guia Del Usuario

BOB Gear by Britax
3� Attach seat retention strap
Loop seat retention strap around
cross tube and secure with
buckle.
Brake
Bar
Correctly Attached Seat Retention Strap
IMPORTANT: Do not loop seat
retention strap around or over
brake bar.
Folding the Stroller
1� Lock Parking Brake
Set parking brake in locked
position.
2� Remove Child From Seat
3� Empty Stroller
Remove contents from low boy
cargo basket and pockets.
4� Unhook Seat Retention Strap
5� Rotate Handlebar
Squeeze both handlebar release
levers simultaneously. Rotate
handlebar forward onto seat.
10
6� Lift Red Frame Release Handle
Using a short, quick tug, lift
red frame release handle up.
Keep tires on ground as stroller
collapses toward front wheel.
7� Lay Stroller Flat
8� Secure Folded Stroller
Use wrist strap buckle to secure
stroller in folded position.
IRONMAN DUALLIE/S.U.S. DUALLIE User Guide
Handlebar
9� Make It Smaller
Take off the front and rear wheels
to make it even smaller. See
Removing Rear Wheel on page
6 and Removing Front Wheel on
page 8.
NOTE: Ensure the handle is
positioned parallel to the ground
before folding.

Checking Tire Pressure

Plastic wheels are rated to a
maximum tire inflation pressure of
30 pounds per square inch (psi).
The maximum inflation pressure is
embossed on the wheel next to the
valve stem.
Aluminum wheels can have the tires
inflated to the pressure embossed on
the tire. However, we recommend 30
psi for a comfortable ride.

Adjusting the Tracking

If stroller pulls left or right when the
stroller is on flat terrain, adjust the
tracking as outlined in the following
steps.
WARNING!
Do not roll test with a child or
any occupant in the stroller�
1� Empty Stroller
Remove contents from low boy
cargo basket and pockets.
2� Check Tire Pressure
3� Place Stroller On Level Ground
Find a stretch of level ground
about 16 feet (4.9 m) long.
16 ft (4�9 m)
4� Align Rear Wheel Axles
Align stroller so rear wheel axles
are perpendicular to a straight
line.
90°
5� Test Alignment
Push stroller straight forward and
release to see if stroller veers right
or left. Repeat push test several
times.
NOTE: If stroller consistently
pulls to left or right, the tracking
can often be corrected by simply
rotating the front wheel axle and/
or reorienting the front wheel by
removing the front wheel, flipping
it around and reinstalling it.
6� Rotate The Front Wheel Axle
Open the front wheel quick
release and rotate axle 90
degrees. Retighten quick release.
See Removing Front Wheel and
Front Wheel Installation sections.
11