Hand Brake; Stroller Operation; Unfolding And Folding - BOB IRONMAN DUALLIE Guia Del Usuario

BOB Gear by Britax
Front Wheel Removal
1� Open Brake Quick Release
See Front Wheel Installation
section.
2� Open Quick Release Lever
Move the wheel's quick release
lever from the locked or FULLY
CLOSED position to the FULLY
OPEN position.
3� Remove Quick Release Axle
Loosen the tension adjusting nut
and remove the quick release axle
from the front wheel and fork.
4� Remove Front Wheel
Raise the front wheel a few inches
off the ground and pull the wheel
out of the front fork.

Hand Brake

If you do not understand these
instructions, or feel the brake
is adjusted incorrectly, take
the stroller to your dealer for
proper adjustment� If your
brake pads are worn, see your
dealer for replacements�
The hand brake may be used to help
slow or stop a stroller. The hand
brake is not a parking brake.
NOTE: For the hand brake to work
correctly, it is critical that it be
adjusted properly. Squeeze the brake
lever and verify that the brake pads
8
contact the rim. Verify brake quick
release is in closed position. See
Front Wheel Installation section.
The hand brake system is equipped
with two barrel adjusters. If you
are not familiar with how to use the
barrel adjusters, please contact BOB
Gear by Britax customer service or
visit your local dealer for assistance.
1� Align Brake Pads
If brakes are misaligned, use a
10mm wrench to loosen brake
pad nuts, slide pads into correct
position and tighten securely.
Brake Caliper
Brake Pad Aligned With Rim
2� Adjust Cable Tension
The cable tension is pre-adjusted
at the factory, but the brake cable
will need periodic adjustment
(as the cable stretches slightly
and the black cable housing
compresses over time).
To adjust cable tension, there
are two barrel adjusters in the
brake system; one at the hand
brake lever, and one at the
caliper brake. To adjust the
brake cable tension, one or both
barrel adjusters may need to be
adjusted.
Hand Brake
Hand Brake
Lock Ring
Lever
Barrel Adjuster
Handlebar
IRONMAN DUALLIE/S.U.S. DUALLIE User Guide
Caliper Brake
Brake Caliper
Barrel Mounting Nut
Adjuster
Lock Ring
Brake Caliper
To tighten the cable, loosen the
lock ring and turn the barrel
adjuster in the counter clockwise
direction. Secure the barrel
adjuster in the new position by
tightening the lock ring against
the caliper or brake lever body.
To loosen the cable, turn the
barrel adjuster in a clockwise
direction and secure by tightening
the lock ring. There should be a
3/16"(5mm) clearance between
the rim and brake pads.
3� Reposition Brake Caliper
If gap is not equal on each brake
pad, the brake caliper can easily
be repositioned on the frame by
loosening the caliper mounting
nut with a 10mm wrench, adjust
caliper position and re-tighten the
same nut.
Brake
Tire
Brake
Pad
Rim
3/16"
(5mm) Gap

Stroller Operation

Unfolding and Folding

Unfolding the Stroller
1� Lift Red Frame Release Handle
Keep tires on ground as stroller
swing arm begins to swing open.
NOTE: Stroller swing arm will
swing open and snap into an
open and locked position.
2� Rotate Handlebar
Lift handlebar up and back until
it snaps into locked and upright
position.
9