Required Tools And Materials; Preparations For Use; Fitting The Light; Connecting Several Lights Together - LIVARNO LUX 14102104L Instrucciones De Utilización Y De Seguridad

Safety / Preparation / Preparations for use
J
Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily to
hand.
J
Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Preparation
Q

required tools and materials

Q
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only.
The nature of the material depends on the individual
circumstances on site.
- Pencil / Marking tool
- Screwdriver
- Electric drill
- Drill
- Spirit level

Preparations for use

Q

Fitting the light

Q
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the two mounting holes a distance of
500 mm apart.
3. Now drill the mounting holes (ø approx. 6 mm,
depth approx. 30 mm). Make sure that you do
not damage any electrical cables during this
operation.
4. Insert the supplied dowels into the drilled holes.
Insert the supplied screws into the dowels and
tighten them. Let them project a distance of about
1.3 mm from the wall or mounting surface.
5. Attach the light using the appropriate mounting
holes or to the screws.
4 8
26 GB/MT
6. When securing the light using the mounting
holes , the light housing
8
pushed all the way to the left, swing the light
strip forward and tighten the mounting
9
screws.
7. Insert the light connector plug of the mains
lead into the light connector socket
13
8. Insert the mains plug of the mains lead
a convenient mains socket. Your light is now
ready for operation.
Connecting several
Q
lights together
CAUtIOn! Make sure that all under-cabinet lights
are linked together by means of the connecting
cables before inserting the power cable
7
the socket.
note: Make sure that you only connect a maximum
of 10 linked-up under-cabinet lights of the same
type to one socket.
Install up to 10 lights of the same model next
to each other. To do so, follow steps 1 – 5 of
the section called "Mounting the lights".
note: Make sure that the distance between
the lights is not more than 21 cm.
Remove the protective head guard
Insert the connecting cable
necting socket of the light.
5
Insert the second connection of the connecting
cable into the socket
7
Insert the connection of the power cable
into the socket of the outer, left-hand light.
1
Insert the mains plug
light is now ready to use.

Switching On / Off

Q
Switch the ON / OFF switch
on or off.
must also be
3
.
1
into
13
into
13
.
6
into the con-
7
of the other light.
1
13
into the socket. Your
13
to turn the light
2