Sage Duo-Temp Pro BES810 Guía Rápida página 9

OPERATING YOUR NEW APPLIANCE
TEXTURING MILK
• Before inserting the steam wand into the milk,
it is recommended to purge the steam wand.
• Set the Control Dial to the 'Steam' position.
• The 'Steam' LED will illuminate.
• Pause the steam by returning the dial back
to the 'Standby' position.
• Insert the steam tip below the surface
close to the right hand side of the jug at the
3 o'clock position and set the Control Dial
to the 'Steam' position.
• Keep the tip just under the surface until the
milk is spinning clockwise, producing a vortex
(whirlpool effect).
• With the milk spinning, slowly lower the
jug, keeping the tip at or slightly below the
surface, until the desired temperature
is reached.
• To stop the steam set the Control Dial to the
'Standby' position and remove the jug.
• Wipe the steam wand with a damp cloth.
HOT WATER
To use the Hot Water function:
• Press the 'SELECT' button and the Hot Water
LED will illuminate.
• Turn the Control Dial to 'Steam'.
To turn the hot water off, turn the Control Dial
to the 'Standby' position.
EN
9