Technical Features; User Safety; Arrangement For Installation - Jacuzzi UNIQUE Ficha Técnica De Preinstalación

It is the responsibility of the installer/owner to ascertain
compliance with specific local regulations prior to installa-
tion. Jacuzzi Europe S.p.A. gives no guarantee in this respect
and declines all responsibility regarding the compliance of
the installation performed.

Technical Features

The Unique ( 1; 2) has a two-speed, 2 HP pump.
Unique is equipped with a cartridge filter that ensures excellent
water filtering (filtering surface: 9.3 m
The Unique hot tub is also available with perimeter panels of the
following types:
- panels with wenge finish
(only for indoor installation).
- panels with teak finish
(for both indoor and outdoor installation).
- panels in synthetic wood
(for indoor or outdoor installation).
- customizable panels, upon which coverings with a thickness of
a few millimetres can be applied.
If you want to apply thicker coverings, you can partially mill the
unfinished panel so that the covering is aligned with the corners
( 2, det. D).
Maximum absorption of the system
Total consumption electric
Power supply (x)
heater + hydromassage
Voltage Hertz Ampere
220-240 ~ 50/60 17 (k)
(k): at 230 V - (j): absorbed power
(x): see "Electrical preparations"
The electrical system that powers the hot tub must absolutely
be sized for maximum consumption (as shown in the table).
Weights
Net weight average fill
kg litres
~ 240 ~ 630
support area concentrated load
on support area
m 2 kg/m 2
~ 2.30 ~ 552
2 ).
Blower Audio System
(optional) (optional)
kW (j) kW (j) kW (j)
3,85 0,6 0,25
water volume Total max. weight
MAX
litres kg
~ 1030 ~ 1270

User safety

If installed by qualified personnel in compliance with the in-
structions in the enclosed installation manual, the system does
not present any risks for the user. However, safety is also contin-
gent upon appropriate use, according to the provisions in the
respective manual, while the user must delegate the operations
described in the installation manual to qualified personnel.
It is important to make sure that personnel tasked to install
or manage the system are qualified as per legal requirements in
effect in the country where installation is carried out.
This appliance uses and generates radio waves: if it is not in-
stalled and used as directed, it may cause interference with the
reception of radio and television programmes.
However, in special cases this may happen even if the instruc-
tions provided are followed.

Arrangement for installation

The site where the hot tub will be installed must be de-
signed to ensure the possible removal and relocation
of the hot tub itself, if necessary.
Models with th Performance filtering unit
The filtering unit (spa-pak) can be placed in any position, but
the maximum distance from the hot tub must not exceed 4 m.
If the installation is made outdoors (in very cold areas) it is rec-
ommended to use valves that make it possible to fully drain the
pipes that connect the hot tub with the spa-pak.
If necessary, the spa-pak can be installed on a lower level (with
respect to the hot tub) with a maximum difference in level of 1
m. Greater differences in level can reduce the flow rate of the
filtration pump.
The spa-pak must be installed so it cannot be accessed by people
without the use of keys, or tools, and be protected from water
and bad weather (suitable ventilation must also be guaranteed).
Unique requires the following plumbing connections (ar-
ranged as in 1 and 3):
- B and possible B1: hot tub drainage.
NOTE: connection "B1" makes it possible to reduce the time re-
quired to drain the tub.
- C: connection of overflow; to be made in the field, after drilling
a hold in the bottom of the support base, depending on the type
of installation.
The customer must make provisions for a ground drainage point
of suitable dimensions and that can be inspected for any clean-
ing that may be required.
14