Allmand NIGHT-LITE PRO II Manual Del Operario página 18

3. Remove the stabilizer jack locking pin (C, Figure 12).
4. Rotate the stabilizer jack (D, Figure 12) 90° into the
operating position, and install the stabilizer jack locking
pin. Make sure the pin is inserted fully through the
stabilizer jack.
WARNING
Rollover Hazard
• Failure to lock the stabilizer jack in the operating
position with the stabilizer jack locking pin could result
in death or serious injury. Be sure the stabilizer jack is
locked in the operating position with the stabilizer jack
locking pin.
5. Unfold the jack handle (E, Figure 12) to the operating
position.
6. Turn the jack handle counterclockwise (F, Figure 12)
until the jack foot (G) is firmly planted on the work site
surface.
7. Repeat for the remaining outriggers and stabilizer jacks.
8. Once all outriggers and stabilizer jacks are deployed, use
the stabilizer jacks and tongue jack to help level the unit
on the work site ground.
To retract
1. Turn the jack handle clockwise to fully raise the jack foot.
2. Fold the jack handle to the transport position.
3. Remove the stabilizer jack locking pin.
4. Rotate the jack 90° to the transport position, and install
the stabilizer jack locking pin. Make sure the pin is
inserted fully through the stabilizer jack.
5. Raise the outrigger locking pin.
6. Retract the outrigger into the transport position. Be sure
the locking pin engages.
WARNING
Unsafe Operation Hazard
• Failure to lock the outrigger in the transport position
could result in death or serious injury. Be sure the
outrigger is locked in the transport position.
7. Repeat for the remaining outriggers and stabilizer jacks.
18
12
Adjusting The Tower Lights
WARNING
Burn Hazard
• Adjusting the tower lights while the lights are on could
result in serious injury. Turn the lights off and wait 10
minutes to cool before adjusting the tower lights.
Note: The tower lights must be adjusted to the preferred work
angle before raising the light tower.
To adjust for operation
Manual (laydown) towers
1. Set each individual light fixture to the preferred work
angle.
• Yoke center pivot (A, Figure 13) - adjusts the
horizontal angle of each individual light fixture. Grasp
the sides of the yoke (B) to adjust.
• Fixture pivots (C, Figure 13) - adjust the vertical angle
of each individual light fixture. Move the light fixture
(D) up or down to adjust.
2. The light tower can also be rotated to provide additional
adjustment of the light angle. See Operation - Raising
And Lowering The Light Tower.