Allmand NIGHT-LITE PRO II Manual Del Operario página 19

13
Hydraulic (vertical) towers - metal halide
1. Set the light bar to the preferred work angle.
a. Pull the park pin (A, Figure 14) and rotate 90° to
unlock the light bar.
b. Rotate the light bar to the preferred work angle.
c. If the light bar rotates loosely or does not remain in
the preferred work position:
• Remove the cap plug from the center of the light
bar.
• Tighten the pivot nut until desired resistance is
achieved.
• Replace the cap plug.
2. Set the tower arms to the preferred work angle.
a. Loosen the adjustment nut (B, Figure 14) on each
tower arm.
Note: Six-light models also feature a park pin similar to the
light bar. Pull and rotate 90° to retract.
b. Rotate each tower arm to the preferred work angle.
c. Tighten the adjustment nuts.
Note: On six-light models, lock each tower arm with the park
pin.
3. Set each individual light fixture to the preferred work
angle.
• Yoke center pivot (C, Figure 14) - adjusts the
horizontal angle of each individual light fixture. Grasp
the sides of the yoke to adjust.
• Fixture pivots (D, Figure 14) - adjust the vertical angle
of each individual light fixture. Move the light fixture
up or down to adjust.
14
Hydraulic (vertical) towers - LED
Note: Six-light model shown. Four-light model similar.
1. Set the light bar to the preferred work angle.
a. Pull the park pin (A, Figure 15) and rotate 90° to
unlock the light bar.
b. Rotate the light bar to the preferred work angle.
c. If the light bar rotates loosely or does not remain in
the preferred work position:
• Remove the cap plug from the center of the light
bar.
• Tighten the pivot nut until desired resistance is
achieved.
• Replace the cap plug.
2. Set the tower arms to the preferred work angle.
a. Loosen the adjustment nut (B, Figure 15) on each
tower arm.
Note: Six-light models also feature a park pin (C) similar to
the light bar. Pull and rotate 90° to retract.
b. Rotate each tower arm to the preferred work angle.
c. Tighten the adjustment nuts.
Note: On six-light models, lock each tower arm with the park
pin.
3. Set each individual light fixture to the preferred work
angle.
• Yoke center pivot (D, Figure 15) - adjusts the
horizontal angle of each individual light fixture. Grasp
the sides of the yoke to adjust.
• Fixture pivots - adjust the vertical angle of each
individual light fixture. Loosen the adjustment nut
(E, Figure 15), move the light fixture up or down to
adjust, then tighten the adjustment nut.
19