Disposal Requirements - Foster Xtra Blast Serie Instrucciones De Funcionamiento

english
GB
installation
IMPORTANT:
To the installer: Installation of these units should be carried out by a competent person and the appropriate codes of
practice adhered to, thus ensuring safe installation.
Pass to the user: Do not discard this document: it contains important guidelines on Operation, Loading,
Cleaning and Maintenance and should be kept for reference.

DISPOSAL REQUIREMENTS

If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in
accordance with National laws and regulations.
Important: Ensure a minimum clearance of 150mm above unit and ventilation for
positioning/unpacking
1
efficient operation. Where possible, ensure the unit is not adjacent to a heat source.
Cabinet
Unpacking: The unit is delivered on a pallet and shrink-wrapped. Documentation is inserted into a clear
pocket located inside the unit. Carefully remove the protective plastic film and cardboard from the
unit exterior and from the door opening surround making sure that any sharp instrument used does not
cause damage, plus remove any quality labels.
Cabinet removal from the pallet: Remove the package containing the castors or legs. Remove the
retaining bolts which secures the unit to the pallet. Move the unit over the front of the pallet and fit the
lockable castors or legs in the mounting holes if required. To fit the rear castors or legs, lock the front
castors, tilt the unit forwards, remove the pallet and fit the castors or legs in the mounting holes. Ensure
that all are tightened firmly into position.
Cabinets fitted with castors - Remove fittings from inside the unit and ensure the door is locked before
removal from the pallet. Cut the heavy duty cable ties that hold the front castors to the pallet. Unlock the
castors and then carefully roll the unit forward off the pallet.
Cabinets fitted with legs - Remove fittings from inside the unit and ensure the door is locked before
removal from the pallet. Remove the fixing blocks located in front of the legs at the front of the unit and
castors legs cut the straps securing the unit to the pallet. Carefully manoeuvre the unit forward, off the pallet.
Castors/legs/feet All models are normally fitted with swivel castors. Ensure during installation the unit is level if not the door may not
2
close correctly. Adjust castors by inserting spacers under the appropriate castor and the base of the unit until level.
As an alternative adjustable legs can be fitted to all models.
Operating Instructions
Controller Operation Prior to starting a chill operation ensure the controller is in the 'stand-by' mode.
3
FXBC Controller
Timed Chill Operation
To place the controller in 'stand–by' press for 2 seconds, whilst in stand-by the cabinet internal air temperature will be displayed intermittently.
Press 'PoS' will be displayed and the Timed Chilling LED
Press to display the chilling time, set to 90 minutes as standard, if no change to the time is required press
If changes to the chill time are required press 'PoS' will be displayed and the Timed Chilling LED
the chilling time followed by to decrease the time or
2
will be flashing.
to start the programme.
will be flashing, press to display
to increase.
23