Cleaning And Maintenance; Technical Service - MO-EL TURBINE 306-30602 Uso Y Mantenimiento

their yarly replacement or at break of 2000 hours of use.

CLEANING AND MAINTENANCE

Before carrying on any cleaning or maintenance operation, make
•
yourselves sure you have disconnected before the equipment form
electrical supply.
Empty the collecting sack and the conveyor ring when the thick-
•
ness of the insect collected at its internal side overcome 15-20 cm
or more , often the sack mashes result to be obstructed.
Check periodically and regularly that the fan turns freely and that
•
in its external area there is no encrustation; if it happens, clean the
conveyor ring.
Before the cleaning of the conveyor ring, disconnect the appliance
•
from the electric supply, wait till the fan stops, then take the col-
lecting sack and the protection grid away. Remove the plastic con-
veyor ring, clean it by water and a soft brush. When re-assembling,
follow the same steps in reverse order.
Clean the lamps from the accumulated dust by means of a soft
•
brush, do not use for cleaning water sprinkles.
Check periodically the protecting grid located between the fan and
•
the collecting sack. If the gris is evn only a bit obstructed , discon-
nect the equipment from electrical supply, wait for the fan stop,
and then remove the sack. Using a soft brush or a blow of com-
pressed air remove the obstruction.
If you notice to have captured useful insects, disconnect the equip-
•
ment , remove the collecting sack and after have gone away from
site quickly to let the insects come out without stinging you.
LAMPS REPLACEMENT
To always have the maximum efficiency, replace the lamps every
2000 hours. To replace them, please call a Service Centre or call the
local authorized distributor.

TECHNICAL SERVICE

If you have any question or problem relevant your Turbine, call the lo-
cal authorized distributor or the nearest Service Centre. Every repairs
should be carried on by an authorized Service Centre and also ask
always for original spare parts.
11