Kohler K-98741-K1 Guía De Instalación Y Cuidado página 12

Fuse
Access
Cover
9. Connect the Cables
IMPORTANT! When possible, connect the cables through the side holes of the PDS rather than the cover
holes to ease cover removal for servicing.
NOTE: Make drip loops in all cables and cords.
Prepare cable ends for installation into the PDS by unthreading the strain relief cap and separating
the rubber stopper from the threaded body. This will prevent the cables from twisting while the
strain relief is threaded into the box.
Insert the chroma power cable into a 1/2" NPT hole and install into the "RAIN PANEL" connector
until it snaps together.
Insert the data cable into a 1/2" NPT hole and install into the "DATA IN" connector until it snaps
together.
Secure the cables and the electrical wire to the PDS using the watertight strain relief fittings. Thread
the fitting into the box, then slide the rubber stopper into the fitting. Tighten the cap to create a seal.
IMPORTANT! Verify all unused holes of the PDS box have plugs installed.
Verify all wires are tucked into the PDS housing and will not be pinched when securing the access
cover.
Reinstall the access cover. Do not overtighten.
Complete the Installation
If not already installed, install the K-99695 system controller according to the instructions packed
with the product.
Connect the data cable into one of the eight grouped component ports on the controller. Refer to the
"DTV+ System Layout" section.
For information on system setup and operation, refer to the guide on the controller product page at
www.us.kohler.com.
Before Operating the System For the First Time:
Download and install the latest software for connected components. This may take an hour or more to
1235394-2-A
Strain Relief Fitting
12
Cap
Chroma
Power Cable
Data Cable
Kohler Co.