INSTALLATION REQUIREMENTS
Turbomax KIT 24 Vdc reliable working temperature shall be LESS than 50°C
Avoid dust, oil fog and corrosive gases
Storage Temperature -20°C; 65°C
Weight Approx. 250 g
USE of TURBOMAX 24V-EV
CONNECTING THE UNIT TO THE ELECTRICAL SYSTEM
BEFORE CONNECTING THE UNIT MAKE SURE THAT THE INPUT LINE IS NOT LIVE (NO POWER) CONNECTIONS WITH
LIVE POWER CAN DAMAGE THE DRIVER
CONNECT THE "LINE IN" CONNECTOR TO THE ELECTRICAL SISTEM
TURN ON THE POWER
CHECK THAT THE GREEN LED IS ON
WARNING: Make sure polarity is correct (Red to Positive). With wrong polarity the Inflator WILL NOT START
WARNING: Exercise with care when connecting the cord to batteries in order not to short the battery with conducting
materials such as rings, bracelets and keys. The battery or conductor may overheat and cause burns.
WARNING: Check the proper Power Voltage. Do not operate below 21Vdc or above 31 Vdc
FITTING THE ACCESSORIES
Make sure that the main Switch is
Remove the high volume inflation hose from the storage location
Press the air hose inside the port to inflate (OUT) or deflate (IN)
Choose the correct valve-adapter from the universal 7-nozzle-kit supplied, depending on the specific valve installed on your
inflatable boat or structure. A proper adapter has to firmly suit the valve and keep the valve open during the inflation or
deflation. Adapters with inner cross-bar are most recommended for electric pumps.
Option Bayonet Valve-Adpaters, for a more stable connection, are available at your closest Bravo Dealer
Install the proper adapter on the inflation hose
Connect the inflation hose to the valve of your inflatable boat or structure
OPERATING THE UNIT
Set the Pressure Knob to the desired limit.
Press the Main Switch to
Press the Start Switch to
The inflator will stop automatically when the inflatable reaches the set value
WARNING: Do not leave the unit running unattended. Over-inflation of items could result in serious injury.
TURBOMAX 24V-EV
OFF
WHEN DEFLATING SET TO 175 mbar.
ON
START
3