Scoprega Turbomax Pumps - SCOPREGA BRAVO TURBO MAX KIT 12V Manual De Instrucciones

SCOPREGA TURBOMAX PUMPS

The TURBOMAX inflator (P/N 6130022 and P/N 6130072), shown in the pictures on the left, has the following
characteristics:
P/N 6130022: INPUT VOLTAGE: Min. 11VDC; Max 13V DC
P/N 6130072: INPUT VOLTAGE: Min. 22VDC; Max 26V DC
Outside of the above range the inflator is not able to reach the maximum pressure or is running at a speed
that can destroy the impeller system. This is due to the fact that a voltage higher than 13 or 26V causes the
DC motor and the impeller to rotate at speeds that can destroy the unit. Due to the above configuration the
two inflators can be connected to batteries at with nominal voltage of 12V or 24V only.
The two units cannot be connected directly to the electrical system of the boat since the voltage fluctuation
can be much higher than the designed limit.
The TURBOMAX KIT 24V-EV inflator (P/N 6130076), shown in the pictures on the right, has the following
characteristics:
The inflator is able to accept an input voltage between 21-31V DC.
The unit has an integrated Servo-Drive microprocessor. Thanks to this configuration the unit can be
connected directly to the boat electrical system, since the Servo-Drive keeps the rotating speed of the
impeller constant independently of the voltage fluctuation. Moreover this inflator shuts down automatically
if the voltage is outside of the voltage limits. This inflator has a noise considerably lower than the one
connected to a battery and a maximum current drain of 25 A, also.