U.S.Robotics 8000 Guia De Instalacion página 6

Possible Solution:
Make sure that your PC is using an IP address that is within the default
range of 192.168.123.xxx. Make sure the address of the subnet mask is
255.255.255.0. To verify these settings, click Windows Start, Settings,
then Control Panel. Double-click the Network icon, select the TCP/IP
protocol for your network, and click Properties.
If you are still unable to connect to the broadband router, refer to the ping
procedure that follows.
I can't access the Internet through the broadband router.
Possible Solution:
Make sure the network cable and the power cord are connected
correctly. Make sure the Ethernet cable is correctly connected to the PC
and to a LAN port on the broadband router.
You can also reset the modem by unplugging it for at least three seconds
then plugging it back in. If you are still unable to access the Internet,
refer to the ping procedure that follows.
My broadband router is not communicating with my
analogue or ISDN modem.
Possible Solution:
Make sure the cables are all correctly installed. If this does not correct
the problem, open the Configuration Utility, click Toolbox, and then click
Reboot. This will restart the broadband router and then it should
communicate with your analogue or ISDN modem.
I can't access the Internet using an analogue or ISDN
modem.
Possible Solution:
Make sure you do not have an Ethernet cable plugged into the WAN port
of the broadband router. You cannot have a modem cable and an
Ethernet cable connected at the same time.
I can't access a printer or files that are being shared.
Possible Solution:
Check each PC and make sure that file and print sharing has been
enabled. Make sure you have the correct drivers for the printer loaded
onto each machine in the network that will use the printer.
6