Troubleshooting; Product Maintenance - HAMPTON BAY Home Depot SKU 522-541 Manual De Instrucciones

TROUBLE SHOOTING:
Problem
Light bulb will not illuminate.
Fuse blows or circuit breaker
t r ips when light bulb is
i l luminated.

PRODUCT MAINTENANCE:

1. To clean the interior and the exterior of the fixture, unplug the power cord from the
120 volt outlet. Use a dry or slightly, water dampened cloth to wipe the surfaces of
the fixture. Allow the fixture to dry thoroughly prior to plugging it back in.
2. To clean the light bulb, use a dry soft cloth and dust off carefully.
CAUTION: DO NOT use any cleaners with chemicals, solvents or harsh abrasives as
damage or fading to the finish and components may occur.
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of one (1) year(s) from date of purchase. This warranty
applies only to the original consumer purchaser and only to products used in normal use
and service. If this product is found to be defective, the manufacturer＇ s only obligation,
and your exclusive remedy, is the repair or replacement of the product at the
manufacturer＇ s discretion, provided that the product has not been damaged through
misuse, abuse, accident, modifications, alterations, neglect or mishandling. This
warranty shall not apply to any product that is found to have been improperly installed,
set-up, or used in any way not in accordance with the instructions supplied with the
product. This warranty shall not apply to a failure of the product as a result of an
accident, misuse, abuse, negligence, alteration, or faulty installation, or any other
failure not relating to faulty material or workmanship. This warranty shall not apply to
the finish on any portion of the product, such as surface and/or weathering, as this is
considered normal wear and tear. The manufacturer does not warrant and specially
disclaims any warranty, whether express or implied, of fitness for a particular purpose,
other than the warranty contained herein. The manufacturer specifically disclaims any
liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor / expense costs involved in the replacement or
repair of said product.
Possible Cause
1. Light bulb is burned out. 1. Replace light bulb.
2. Power is off.
3. Faulty switch.
Crossed wires or power
wire is grounding out.
LIMITED WARRANTY
4
Corrective Action
2. Make sure power supply is on.
3. Test or replace switch.
Check wire connections or
consult a qualified, licensed
electrician.