Troubleshooting - A&D Medical UA-651BLE Manual De Instrucciones

Problem
Nothing
appears on
the display,
even when
the power is
turned on.
The cuff
does not
inflate.
The device
does not
measure.
Readings
are too high
or too low.
Other
Note: If the actions described above do not solve the problem, contact the
dealer. Do not attempt to open or repair this product, as any attempt to do
so will make your warranty invalid.
A&D Medical (Toll-Free): 1-888-726-9966
Possible Reason
Batteries are
drained.
Battery terminals
are not in the
correct position.
Battery voltage is too
low. blinks. If
the batteries are
drained completely,
the mark does not
appear.
The cuff is not
applied properly.
You moved your
arm or body during
measurement.
The cuff position is
not correct.
The value is
different from that
measured at a clinic
or doctor's office.
R ecommended Action
Replace all batteries with new
ones.
Reinstall the batteries with
negative and positive terminals
matching those indicated on the
battery compartment.
Replace all batteries with new
ones.
Apply the cuff correctly.
Make sure you remain still and
quiet during measurement.
Sit comfortably and still. Place
your arm on a table with your palm
facing upward and the cuff at the
same level as your heart.
If you have a very weak or
irregular heat beat, the device may
have difficulty in determining your
blood pressure.
Remove the batteries. Place them
back properly and take another
measurement.

TROUBLESHOOTING

E-20