STACK-ON SHD-SU-BG-B Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SECURING THE SAFE
NOTE: The safe must be secured to the floor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: This safe must be mounted to the floor.
Failure to do so will compromise the safety and
security of the safe.
Mark the holes to be used. Drill the appropriate
diameter and depth of pilot holes depending on the
type of hardware being used and the type of
mounting surface.
Secure the safe with the fasteners.
BACK UP KEY
A "Back Up Key" has been provided in case the
batteries run low. If you lose your key, you may
purchase a replacement key be referencing the
serial number located on the back of your safe
or the front lower right corner. See section
regarding replacement keys for further
information.
1. Remove the cover by pressing the tab and
turning the cover as shown in the illustration.
The lock can hang by the connecting cable while
unlocking the safe.
TAB
2. Insert the key in the key hole and turn
clockwise 1/4 turn (until stopped) in order to
unlock the safe. Rotate the handle and open
the door.
3. Keep the door open until you have recorded a
new fingerprint. Before entering your new
recorded fingerprint remove the key and screw
the cover back in place.
4. Scan your new fingerprint following the
instructions for recording your fingerprint.
5
16
40717-1704

Publicidad

Tabla de contenido
loading

Tabla de contenido