Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPENING THE SAFE USING YOUR
FINGERPRINT
To activate the scanner, touch the scanner or face
plate anywhere with a recorded finger - the green
light flashes once with one beep (if the sound is
turned on). The blue light will come on, now scan
the recorded fingerprint.
If the green light flashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted
and you will have 5 seconds to turn the handle to
open the door.
If the red light flashes once, the scanner did not
read your fingerprint and you must try again. If the
red light flashes 3 times, the scanner read your
fingerprint and did not accept it.
If there are 3 rejected scans, where your
fingerprint was read, and the red light flashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 60
seconds before you can try a scan again. The
safe will beep one time (if the sound is turned
on) and the green light will flash once when the
lockout period is over.
If there is 1 more rejected scan where your
fingerprint was read and the red light flashes 5 times
with 5 beeps (if the sound is turned on), you will
have an automatic lockout for 5 minutes before you
can try a scan again. The safe will beep one time (if
the sound is turned on) and the green light will flash
once when the lockout period is over.
LOCKING THE SAFE
To lock the safe, close the
door and rotate the handle
clockwise until it stops. If the
handle is not turned until it
stops, the locking mechanism
will not lock.
NOTE ON LOCKING THE SAFE:
Because the locking mechanism is deactivated
for approximately 3 to 6 seconds after the
fingerprint is entered, wait a minimum of
6 seconds from the time the scan is entered to
lock the safe.
TURNING THE SOUND OFF/ON
Your safe comes with the beep sound turned on.
To turn the sound off, press the scanner with a
recorded fingerprint for 10 seconds until the
green light flashes twice.
To turn the sound on, press the scanner with a
recorded fingerprint until you hear two beeps and
the green light flashes twice.
CLEARING THE MEMORY
To clear the memory of all recorded
fingerprints, locate the reset button on the
inside of the safe and press this button for
about 5 seconds until the green light flashes 10
times with 10 beeps (if the sound is turned on).
All recorded scans will be erased.
NOTE: For security you must record a
fingerprint. Failure to do so will compromise
the safety and security of the safe.
SELECTING A LOCATION
The safe must be mounted to the floor. For
optimal safety and security, the safe should
be installed adjacent to a side wall with
minimal space on either side of the safe, in an
isolated, dry and secure area.
The safe should be flat against the wall and
floor. Remove the baseboard if necessary.
CHILDREN SHOULD NOT PLAY WITH OR
AROUND THE SAFE AT ANY TIME.
4
16
40717-1704
Publicidad
Tabla de contenido
