Switching On And Off; Working With The Lawnmower - Grizzly ERM 1231-2 G Traducción Del Manual De Instrucciones Original

(5) in the required position. All
wheels must be adjusted at the
same level.
The correct height is around 30 – 45 mm
for a decorative lawn and around
mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Observe the noise protection and
local regulations.

Switching On and Off

G 1. Plug the mains lead into the
extension cable outlet (
the curved handle (
2. Turn the end of the mains lead
into a loop and hook it into the
cable strain relief (10).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (11) on the handle at the
same time as pressing the start
lever (12). Release the release
button (11).
4. To switch off, release the start
lever (12).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.

Working with the Lawnmower

Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
45 - 60 each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
•
•
A
9) at •
A
).
•
•
•
Start mowing near the socket and work
away from the socket.
Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
Run the equipment at a walking pace,
in tracks that are as even as possible.
For gap-free mowing, the tracks should
always overlap by a few centimetres.
Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
Clean the equipment after each use,
as described in the chapter on "Clean-
ing, Maintenance and Storage".
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait un-
til the blade stops. There is a risk
of injury.
GB
51