GE Advantium ZSC2201 Manual Del Propietário página 34

Questions?
Problem
Use this LIGHTS
Light during a speedcook
problem
cycle dims and cycles
solver
on and off, even at full
power levels
Light visible around the
door and outer case
while speedcooking
COOLING FANS
Fan continues to run
after cooking stops
Oven vent emits warm air
while oven is on
Fan comes on
automatically when using
the microwave
COOKING
The oven makes unusual
sounds while cooking
Smoke comes out of the
oven when I open the
door
Food is not fully cooked
or browned at the end of
a program
SENSOR ERROR
displayed along with an
oven signal
34
Troubleshooting
Possible Causes
This is normal.
Power level has been
automatically reduced
because the oven is hot.
This is normal.
The oven is cooling.
This is normal.
This is normal.
Clicks are normal. The
control is turning the
components on and off.
Fan noise is normal.
Fans are required to keep
the oven components
and controls cool.These
sounds are normal.
Food is high in fat
content. Aerosol spray
used on the pans.
Programmed times may
not match the sizeor
amount of food you are
cooking.
Food amount or type
placed in the oven does
not match the program
that was set.
Steam was not sensed by
the oven because plastic
wrap was not vented,
a lid too tight was on
the dish or a liquid was
covered.
Advantium Oven
What To Do/Explanation
This is normal. The oven senses the
heat level and adjusts automatically.
When the oven is on, light may be
visible around the door and outer case.
The fans will automatically shut off
when the internal parts of the oven have
cooled.
These sounds are normal.
Smoke is normal when cooking high-fat
foods.
Adjust time for doneness or adjust the
upper or lower lamps for browning and
cooking doneness.
Press the CANCEL/OFF pad. Set the
oven program to match the food or
liquid to be cooked or heated.
Vent plastic wrap, use a looser lid
or uncover liquids when cooking or
heating.