Measuring Weight Only - Beurer BG 28 Instrucciones Para El Uso

3. Operation
3.1 Batteries
If present, pull the battery insulating strip off the battery compartment cover or re-
move the battery's protective film and insert the battery according to the polarity.
If the scale fails to operate, remove the battery completely and insert it again. Your
scale is equipped with a "replace battery" indicator. When the scale is operated with
a battery which is too weak, "Lo" appears in the display field and the scale auto-
matically switches off. The battery must be replaced in this case (3 V lithium battery
CR2032). The used, completely drained standard and rechargeable batteries must
be disposed of in specially marked collection containers, at toxic waste collection
points or electrical product retailers. You are legally obligated to dispose of the bat-
teries.
Note: Batteries containing pollutants are marked with the following symbols:
Pb = Battery contains lead, Cd = Battery contains cadmium, Hg = Battery contains
mercury.
Place the scale on a firm, flat surface; a firm floor covering is a basic requirement for
correct weight measurement.

3.2 Measuring weight only

Place the scale on a firm level floor (no carpet); a firm floor covering
is required for correct measurement.
Audibly, briefly and firmly tap the scale with your foot to active the
vibration sensor!
The entire display (Fig. 1) appears up to "0.0" (Fig. 2) as a self-test (tap-
on technology).
Now the scale is ready to measure your weight. Stand on the scale wi-
thout moving about and distribute your weight evenly on both legs. The
scale immediately begins to measure your weight. Your measured weight
is displayed shortly after this (Fig 3). The scale switches off a few se-
conds after you step down from it.
3.3 Measuring weight, body fat, body water and muscle
percentage
– First your personal parameters must be stored;
– Briefly step onto the scale first and wait until the display "0.0" (Fig. 2)
appears. Then press "SET". Now the first memory preset flashes in the
display (Fig. 4). Select the desired preset by pressing the buttons "up"
or "down" and confirm the desired preset with the "SET" button.
– Now height in cm (inch) flashes in the display (Fig. 5). Set the desired
value by briefly pressing or holding the buttons "up"
and confirm it by pressing "SET".
– "Age" in years then flashes in the display (Fig. 6). Set the desired value
by briefly pressing or holding the buttons "up"
confirm it by pressing "SET".
– The sex setting "Woman" or "Man" appears on the display (Fig. 7). Se-
lect your sex by pressing the buttons "up"
by pressing "SET".
– Now the setting for your individual level of activity or fitness appears
on the display (Fig. 8). Select the desired level of activity by pressing
the buttons "up"
vity with the "SET" button.
– The values you've just set are displayed again consecutively.
or "down" and confirm the desired level of acti-
or "down"
or "down" and
or "down" and confirm
10
Pb Cd Hg
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6