Broan B5936SS Manual De Instrucciones página 7

(8) M4 x 10mm
PAN HEAD
MACHINE
SCREWS
9. Attach the hood assembly to the ceiling bracket using (8)
M4 x 10mm machine screws (2 for each support leg).
10. Connect power cable to house wiring. Black to Black,
White to White, and Green to Green or Bare wires. Secure
power cable to wiring box with appropriate connector.
(4) M4 x 8mm
SHEET METAL
SCREWS
11. Slide the inner flue up to the ceiling and secure with (4) M4
x 8mm sheet metal screws.
12. Remove the protective coating from the hood and the
outer flue.
F R
O N
T
NON-DUCT
FILTER
MOUNTING
TABS
METAL
LATCH
GREASE
FILTERS
13. Remove the grease filters by pulling down the metal latch
tab and tilting the filters downward to remove.
14. Install the non-duct recirculation filter as shown. Turn
mounting tabs on hood to secure filter.
15. Reinstall grease filters by aligning rear filter tabs with
slots in the hood. Pull down the metal latch tab, push filter
into position and release. Make sure filters are securely
engaged after installation.
MODEL B5936SS
Page 7
NON-DUCT
RECIRCULATION
FILTER