Leuze electronic IPS 208i Manual Del Usuario página 11

Safety
This sensor was developed, manufactured and tested in line with the applicable
safety standards. It corresponds to the state of the art.
Intended use
The positioning sensors of the IPS 200i series are designed for optical, contact-
less fine positioning relative to a marker for use in steel construction, e.g. on high-
bay storage devices in conveyor and storage systems.
Areas of application
The camera-based positioning sensors of the IPS 200i series are especially de-
signed for the following areas of application:
– Compartment fine positioning in high-bay pallet storage systems
– Small-part container storage systems
CAUTION
Observe intended use!
The protection of personnel and the device cannot be guaranteed if the
device is operated in a manner not complying with its intended use.
Ä
Only operate the device in accordance with its intended use.
Ä
Leuze electronic GmbH + Co. KG is not liable for damages caused
by improper use.
Ä
Read this supplement and the operating instructions for the device
before commissioning the device. Knowledge of these documents
is required in order to use the equipment for its intended purpose.
NOTICE
The positioning sensors of the IPS 200i series correspond to the fol-
lowing classification with respect to the integrated illumination:
Ä
Infrared illumination: Exempt group in acc. with EN 62471.
NOTICE
Comply with conditions and regulations!
Ä
Observe the locally applicable legal regulations and the rules of
the employer's liability insurance association.
Foreseeable misuse
Any use other than that defined under "Intended use" or which goes beyond that
use is considered improper use.
In particular, use of the device is not permitted in the following cases:
– in rooms with explosive atmospheres
– in circuits which are relevant to safety
– for medical purposes
EN
11