Prepare The Installation - Best CPD9M Serie Instrucciones De Instalación

1. PREPARE THE INSTALLATION

NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Power Pack
- Accessories • Baffle filters with handles
• 10" round adapter
• Bag of parts including: 1 wire clamp, 2 waterproof wire connectors, 9 no. 8 x 5/8" type A screws,
Parts sold separately:
• Blower assembly model P12NA.
2. INSTALL THE DUCTWORK AND ELECTRICAL WIRING
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
This power pack is not designed for use with a charcoal grill.
This range hood is intended for outdoor covered patio or lanai area. As with all electric appliances, this unit must
be protected from the effects of the weather.
These power packs must be installed with the P12NA blower (sold separately). Do not substitute for an other blower.
Plan where and how the ductwork will be installed. A straight, short duct run will allow the hood to perform most efficiently.
Install 10-inch ductwork, elbows and roof or wall cap. Connect metal ductwork to the cap and work back towards the hood location. Use
2" metal foil duct tape to seal the joints.
Run 3-wire power supply cable to installation location.
The power cable must be a GFCI protected branch circuit.
The power pack must be installed at least 36'' above the cooking surface
2 no. 8-18 x 3/8" screws, 1 suction cup.
WARNING
!
CAUTION
WARNING
!
ROOF CAP
10" ROUND DUCT
10" ROUND ELBOW
WALL
CAP
36" ABOVE COOKING SURFACE
HH0270A
3
POWER PACK