Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10
SAFETY WARNINGS
10.1 Warnings for the installer
Observe the prescriptions contained in this
manual.
The instructions for assembly and
disassembly of the appliance are reserved
for specialist technicians only.
The installation and connections of
the appliance must be carried out by
qualified personnel.
The installer must comply with all local, national
and European safety regulations.
Before starting the installation or disassembly
of the fireplace, the installer must comply with
the safety precautions required by law and in
particular:
• must not operate in adverse conditions;
• operate in perfect psychophysical conditions
and must check that the personal protective
equipment is intact and functioning
perfectly;
• must always use the personal protective
equipment and other means of protection
provided by law;
• must use electrically insulated tools;- the
installer must ensure that the area involved
in the assembly/disassembly phases is free
from obstacles.
10.2 Warnings for the user
Observe the prescriptions contained in this
manual.
The appliance, being a heating product,
has particularly hot external surfaces. For
this reason, we recommend the utmost
caution during operation; in particular:
•
do not touch and do not approach
the glass of the door, it could cause
burns;
•
do not touch any part of the chimney;
•
do not perform any type of cleaning;
•
do not offload the ashes;
•
keep children out of reach.
Observe the instructions and warnings
highlighted by the plates on the product.
The plates are safety devices, therefore they
must always be perfectly legible. If these are
damaged and unreadable, it is mandatory to
replace them, requesting the original spare
parts from the Manufacturer.
Use only the fuel complying with the indications
given on the chapter relating to the fuel
characteristics.
F o l l o w t h e r o u t i n e a n d e x t r a o r d i n a r y
maintenance schedule carefully.
Do not use the stove without first performing
the daily inspection as prescribed in the section
"Maintenance and Cleaning" of this manual.
Do not use the stove in case of abnormal
operation, suspicion of breakage or unusual
noises.
Do not throw water on the stove in operation or
to extinguish the fire in the fire box.
Do not lean on the open door, it could
compromise its stability.
Do not use the stove as anchoring or support
of any type.
Do not clean the appliance until the structure
and the ashes are completely cooled down.
Perform all operations in maximum safety and
calm.
In the event of a fire in the fireplace, try to
extinguish the fire in the stove by shutting off
all the primary air necessary for combustion and
immediately call the emergency service.
In the event of malfunction of the appliance due
to a not optimal forced draft of the flue, clean
the same according to the procedure described
in paragraph 7.2.1 using qualified personnel.
A not optimal forced draft in the flue system can
also be caused by particularly adverse weather
conditions (typically low pressure or particularly
windy areas): in this case it is necessary to heat
the flue system well, by correctly performing the
ignition according to the procedure described
in paragraph 6.3.
10.3 Warnings for the maintenance
Observe the prescriptions contained in this
manual.
Always use the personal protective equipment
and other means of protection provided by law.
Before starting any maintenance operation,
make sure that the stove, if it has been used,
has cooled down.
If even one of the safety devices is found to be
out-of-adjustment or not functioning, the stove
should be considered as not functioning.
004773952 - 14/11/2019 - Italy
technician
19
Publicidad
Tabla de contenido
