Vibration; Labels And Symbols - Evolution Evosaw Instrucciones Originales

www.evolutionpowertools.com
Note: The vibration measurement was
(1.6)
made under standard conditions in accordance
with: BS EN 61029-1:2009
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one
tool with another. The declared vibration
total value may also be used in a preliminary
assessment of exposure.

VIBRATION

(1.7)
WARNING: When using this machine the
operator can be exposed to high levels of
vibration transmitted to the hand and arm.
It is possible that the operator could develop
"Vibration white finger disease" (Raynaud
syndrome). This condition can reduce the
sensitivity of the hand to temperature as well
as producing general numbness. Prolonged or
regular users of this machine should monitor
the condition of their hands and fingers closely.
If any of the symptoms become evident, seek
immediate medical advise.
• The measurement and assessment of
human exposure to hand-transmitted
vibration in the workplace is given in:
BS EN ISO 5349-1:2001 and
BS EN ISO5349-2:2002
• Many factors can influence the actual
vibration level during operation e.g. the
work surfaces condition and orientation
and the type and condition of the machine
being used. Before each use, such factors
should be assessed, and where possible
appropriate working practices adopted.
Managing these factors can help reduce
the effects of vibration:
Handling
• Handle the machine with care,
allowing the machine to do the work.
• Avoid using excessive physical effort
on any of the machines controls.
• Consider your security and stability,
and the orientation of the machine during use.
Work Surface
• Consider the work surface material;
its condition, density, strength, rigidity
and orientation.
WARNING: The vibration emission during
actual use of the power tool can differ from the
declared total value depending on the ways
in which the tool is used. The need to identify
safety measures and to protect the operator
is based on an estimation of exposure in the
actual conditions of use (taking account of all
parts of the operating cycle, such as the times
the tool is switched off, when it is running idle,
in addition to trigger time).
LABELS & SYMBOLS
(1.8)
WARNING: Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools for
replacement labels.
Note: All or some of the following symbols may
appear in the manual or on the product.
(1.9)
Symbol Description
V
A
Hz
min
-1
~
Alternating Current
n o No Load Speed
Double Insulated
Wear Safety Goggles
Wear Ear Protection
Wear Dust Protection
5
Volts
Amperes
Hertz
Speed
EN