Jøtul C 31 Instrucciones Para Instalación página 10

ENGLISH
Table of contents
1.0 Relationship to the authorities ............... 10
2.0 Technical data ......................................... 10
3.0 Safety precautions .................................. 10
4.0 Installation ............................................... 11
5.0 Use ............................................................ 12
6.0 Maintenance ............................................. 13
7.0 Service ...................................................... 14
8.0 Operational problems - troubleshooting
14
9.0 Optional Equipment ................................ 15
10.0 Recycling ................................................ 15
11.0 Guarantee terms .................................... 15
Figures............................................................ 54
Register your fi replace at jotul.com for a
25-year warranty.
On all our products there is a label
Product:
Jøtul
indicating the serial number and
Room heater fired by solid fuel
year. Write this number in the
Standard :
Minimum distance to adjacent combustible materials:
Minimum distance to adjacent combustible materials:
place indicated in the installation
Emission of CO in combustion products :
Flue gas temperature :
Nominal heat output :
Efficiency instructions.
:
Operation range :
Fuel type
:
Operational type :
The appliance can be used in a shared flue.
Always quote this serial number
Country Classification Certificate/ Approved by
standard
Norway Klasse II when contacting your retailer or
SP Sveriges Provnings- och
SP
Sweden OGC
Forskningsinstitut AB
Jøtul.
SP Swedish National
Testing and Research
EUR Intermittent EN
Institute
Follow user`s instructions. Use only recommended fuels.
Montage- und Bedienungsanleitung beachten.
Verwenden Sie nur empfohlenen Brennstoffen.
Respectez les consignes d'utilisation. Utilisez uniquement
les combustibles recommandés.
Serial no: Y-xxxx, Year: 200x
Manufacturer: 221546
Jøtul AS
POB 1441
N-1602 Fredrikstad
Norway
10
Serial no.
1.0 Relationship to the
authorities
Installation of a fi replace must be according to local codes
and regulations in each country.
All local regulations, including thosethat refer to national
and European standards, shall be complied with when
installing the product.
Instructions for mounting, installation and use are enclosed with
the product. Prior to using the product the installation must be
inspected by a qualifi ed person.
A product data label in heat resistant material is located on the
heat shield at the back of the product. This contains information
about identifi cation and documentation for the product.
2.0 Technical data
Material: Cast iron
Finish: Blue Black Enamel
Fuel: Wood
Log length, max.: 55 cm
Flue outlet: Top
Flue dimension : Ø 150 mm/177 cm
Hot air distributor: Ø 150
Approx. weight: 143 kg
Options extras:
Dimensions, distances etc.: See fi g.1
Technical data according to EN 13229
Nominal heat output:
Smoke gas mass fl ow:
Recommended chimney draught:
Effi ency:
CO emission (13% O ):
2
Flue gas temperature:
Operating mode:
3.0 Safety precautions
3.1 Fire preventive measures
Any use of the fi replace may represent some danger.
Therefore, respect the following instructions:
• Ensure that furniture and other fl ammable materials do not
get too close to the fi replace.
• Let the fi re die. Never put it out with water as this may
damage the product.
• The fi replace gets warm when used and may cause burns
if touched.
• Only remove the ashes when the stove is cold.
• Ash must be properly disposed of outdoors, or emptied
where it does not entail a fi re hazard.
cross section
2
8,0 kW
6,4 g/s
12 Pa
73%@7,1 kW
0,20%
339 C
0
Intermittent