Switch Off - Vetus MPE1MB Manual De Usuario

3 Operation
3 .1 Switch on
Make sure that the on-board power supply and the power supply of
the V-CAN line are switched on.
When the power is switched on, all LED symbols light up momentarily.
3 .2

Switch off

• Switch off the power. When the power is off, all LEDs are off.
• Turn off the on-board power.
3 .3 Meaning LED indicator lights
Startup sequence
Propulsion active (propeller moving) - Normal mode
Power mode active. Propeller not moving
Propulsion active (propeller moving) - Power mode
CAN warning - Blockage (overload)
CAN alarm - High voltage (alternating red/green)
Overheating warning (motor is limited but functional)
Overheat alarm
High motor current (voltage battery indication impossible)
Voltage ± 100 % *
Voltage ± 60-95 % *
Voltage ± 50-60 % *
Voltage ± 40-50 % *
Voltage ± 40 % (power is limited) *
Voltage ± 30 % (system does not work) *
Charging battery **
* Battery indication based on measured voltage. When continuously using more power the sailing range with the E-DRIVE decreases and
the indication will show a lower percentage. If the energy consumption is reduced (sailing slower), the indication may increase again.
Note: only indicative. Use a battery monitoring system for more exact data.
** This indication remains active until a few minutes after active use of the e-drive. Only then will the battery indication be based on the
voltage.
vetus® Owner's manual MPE1MB E-Line Monitoring Panel
When switched on, all LED symbols light up momentarily
x
(x)
(x) x
x (x)
x
x
x x
x
x
ENGLISH
red green green
(x) (x) (x) (x)
x x
x
x
x x (orange)
x x
x x
x x
(x) = flashes, x = continuously on
370601.01
green
(x)
x
(x)
7