Publicidad
Idiomas disponibles
Idiomas disponibles
Photo 27
7.10 ADJUSTING THE SOLUTION WATER
FLOW
The flow of the solution water can be adjusted
operating the tap located on the right of the control
panel.
Set the solution flow control lever in an interme-
diate position between the closed ( Photo 28 - A )
and fully opened ( Photo 28 - B ) position, accor-
ding to the kind of cleaning to be performed.
The machine is provided with a solenoid valve; the so-
lution water outlet occurs only when the machine is
working, by pulling the control lever ( Photo 2 - A );
to allow the water solution outlet it is necessary to
set the brush motor switch to the "ON" position. (
Foto 5 - C ; Foto 7 - C ).
A
Photo 28
A) Water flow adjusting lever
B: tap closed
C: tap opened
7 - OPERATING INFORMATIONS
B
C
7.11 DRIVING THE MACHINE
Model "E"
- Connect the power cable of the machine to the
power mains using a patch cord.
- Switch ON the general ON-OFF switch ( Photo 5 -
A ).
- Switch ON the brush motor switch (Photo 5 - C)
- Switch ON the suction motor switch (Photo 5 - B).
- Open the solution water valve rotating the lever (
Photo 4 - A )( Photo 28 ).
- Lower the squeegee unit by using the lift/lower
lever ( Photo 4 - B ).
- Wash the floor moving forward slowly.
!
(
) Remember to lift the squeegee before driving
reverse to avoid damaging it.
Model "B" - "BT"
- Put the ignition key ( Photo 4 - H ) in and turn ON
the machine.
- Check the battery charge status on the battery
power test placed on the control panel ( Photo 4 -
E ).
- Switch ON the brush motor switch ( Photo 6 - A )
( Photo 7 - A )
!
(
) The brush will start the rotation only
when the operator will pull the brush opera-
tion lever ( Photo 2 - A ).
- Switch ON the suction motor switch ( Photo 6 - B
) ( Photo 7 - B ).
- Open the solution water valve rotating the lever (
Photo 4 - A )( Photo 28 ).
- Lower the squeegee unit by using the lift/lower
lever ( Photo 4 - B ).
- Wash the floor moving forward slowly, pulling the
brush operation lever ( Photo 2 - A ) to start the
brush rotation and the solution water outlet; re-
leasing the lever the brush rotation will stop after
few seconds.
!
(
) Remember to lift the squeegee before driving
reverse to avoid damaging it.
7.12 WORK METHOD
7.12.1 PREPARATION AND WARNINGS
Remove any loose solid residue from the surface to
be treated (using suitable tools, such as vacuum
cleaners, sweepers, etc.). It this is not done, the
solid dirt might prevent the squeegee from operat-
ing correctly, reducing drying efficiency.
Only trained personnel can drive this machine.
7.12.2 BATTERY CHARGE LEVEL CONTROLS
The sequence of lights of the battery power test (
Photo 7 - D ) shows the battery discharging (green
light = battery fully charged; yellow light = battery
half charged; red light = battery discharged). When
40
Publicidad
Capítulos
