The model number and serial number of this product can be found on
either the back or the bottom of the unit.
Please note them in the space provided below and keep for future
reference.
MODEL NUMBER
SC-HC40
SERIAL NUMBER
User
memo:
DATE OFPURCHASE
DEALER
NAME
DEALER
ADDRESS
TELEPHONE
NUMBER
FCC Note:
This equipment
has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection
against
harmful interference
in a residential
installation. This equipment
generates,
uses and can radiate radio frequency
energy and, if not
installed and used in accordance
with the instructions,
may cause
harmful interference
to radio communications.
However, there is no guarantee
that interference
will not occur
in a particular installation.
If this equipment does cause harmful
interference
to radio or television
reception, which can be determined
by turning the equipment off and on, the user is encouraged
to try to
correct the interference
by one or more of the following
measures:
O Reorient or relocate the receiving antenna.
O Increase the separation
between the equipment
and receiver.
O Connect the equipment
into an outlet on a circuit different from that
to which the receiver is connected.
O Consult the dealer or an experienced
radio/TV technician for help.
FCC caution: To maintain compliance
with FCC regulations,
shielded
interface cables must be used with this equipment.
Operation
with non-approved
equipment or unshielded cables may result in
interference
to radio and TV reception. Any changes or modifications
not approved by the party responsible
for compliance
could void the
user's authority to operate this equipment.
This device complies
with Part 15 of the FCC Rules.
Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference
received, including
interference
that may cause undesired
operation.
Responsible
Party:
Panasonic
Corporation
of North America
One Panasonic Way
Secaucus,
NJ 07094
Support Contact:
Panasonic
Consumer
Electronics
Company
Telephone
No.: 1-800-211-PANA
(7262)
_
WARNING:
To satisfy FCC RF exposure
requirements
for mobile transmitting
devices, a separation of 20 cm or more should be maintained
between
the antenna of this device and persons during device operation.
To
ensure compliance,
operations at closer than this distance are not
recommended.
The antenna used for this transmitter
must not be
co-located
in conjunction
with any other antenna or transmitter.
FCC ID: ACJ-B21
=R10001
This device complies
with Part 15 of the FCC Rules. Operation is
subject to the following
two conditions:
(1) This device may not cause harmful interference,
(2) This device must accept any interference
received, including
interference
that may cause undesired
operation.
The Bluetooth
word mark and Iogos are owned by the Bluetooth
SIG, Inc. and any use of such marks by Panasonic Corporation
is
under license. Other trademarks
and trade names are those of their
respective
owners.
(
)
u.pznt
sU hyt;htt
n,t w Z':t c Urn?;S:d
how you can maximize the fun and excitement
your equipment offers.
This manufacturer
and the Electronic Industries Association's
Consumer
Electronics
Group want you to get the most out of your equipment by
playing it at a safe level. One that lets the sound come through
loud
and clear without annoying blaring or distortion-and,
most importantly,
without affecting your sensitive hearing.
We recommend
that you avoid prolonged
exposure to excessive
noise.
Sound can be deceiving. Over time your hearing "comfort level" adapts to
higher volumes of sound. So what sounds "normal" can actually be loud
and harmful to your hearing.
Guard against this by setting your equipment
at a safe level BEFORE
your hearing adapts.
To establish a safe level:
Start your volume control at a low setting.
Slowly increase the sound until you can hear it comfortably
and
clearly, and without distortion.
Once you have established
a comfortable
sound level:
Leave it there.
Taking a minute to do this now will help to prevent hearing damage or
loss in the future. After all, we want you listening for a lifetime.
1. Damage requiring service -- The unit should be serviced
by
qualified service personnel
if:
(a) The AC power supply cord or the plug has been damaged;
or
(b) Objects or liquids have gotten into the unit; or
(c) The unit has been exposed to rain; or
(d) The unit does not operate normally or exhibits a marked change in
performance;
or
(e) The unit has been dropped or the cabinet damaged.
2. Servicing
-- Do not attempt to service the unit beyond that described
in these operating
instructions.
Refer all other servicing
to authorized
servicing personnel.
3. Replacement
parts -- When parts need replacing ensure the servicer
uses parts specified
by the manufacturer
or parts that have the same
characteristics
as the original parts. Unauthorized
substitutes
may
result in fire, electric shock, or other hazards.
4. Safety check -- After repairs or service,
ask the servicer to perform
safety checks to confirm that the unit is in proper working condition.
[
Product
information
[
For product information
or assistance
with product operation:
Refer to "Customer Services Directory (United States and Puerto Rico)"
on page 17.
"Made for iPod" means that an electronic
accessory nas been
designed to connect specifically to iPod and has been certified by me
developer
to meet Apple performance
standards.
"Works with Phone" means that an electronic
accessory
nas Deer
designed to connect specifically to iPhone and has been certified by
the developer to meet Apple performance
standards.
Apple is not responsible
for the operauon of this device or its
compliance
with safety and regulatory
standards.
iPod is a trademark of Apple Inc., registered
ntne
U.S. and other
countries,
iPhone
s a trademark of ADD_e nc
o
m
3