Standard Equipment; Equipment And Optional Accessories - Hupfer TTW/M1/16 B-EN-115 Manual Del Usuario

Description and Technical Data
Appliance Description
3.4.3

Standard equipment

The tray transport trolley is completely made of stainless steel and double-walled. The modular design al-
lows easy replacement of damaged parts (e.g. side walls, middle wall, doors, push bars, bumpers and roof
of the trolley).
The side walls are equipped with seamlessly deep-drawn beads at a distance of 4.13'' (105 mm) (optionally
also 3.74 or 4.13'' (95 mm or 105 mm)).
The side walls of the tray transport trolleys can be equipped with an embossed tilt protection when they are
not used together with inductive docking stations.
Big radiuses, smooth surfaces and the seamless fabrication of the side and middle walls enable an easy
cleaning of the interior. The middle walls can be removed for a thorough cleaning of the appliance.
You can swing the folding doors to an angle of 270° and lock them. The transport safety device safely locks
the doors during transportation.
Due to the vertical push bars in the corners of the trolley it is possible to fully load the appliance and easily
manoeuvre the device when the doors are closed or opened.
The corrosion-resistant swivel casters with total brakes and fixed casters made of galvanised and chrome-
plated housings ensure an optimal movement and manoeuvrability of the tray transport trolley.
The lower peripheral frame made of shock-resistant plastic offers an optimal bumper and on the right and
left sides it is disconnected in the mid for the optional installation of the coupling and drawbar.
3.4.4

Equipment and optional accessories

You can install and fit the tray transport trolleys with optional accessories in various ways.
Gallery:
The gallery and a non-slip pad allow to use the roof of the trolley as an additional and secure stor-
age surface. The roof of the trolley may be loaded with up to 55 lbs (25 kg).
Central total brake:
The optional central total brake provides a firm hold during standby mode. One single foot control
locks both swivel casters of the tray transport trolley.
Casters that are movable in only one direction:
Due to the equipment of the casters, the swivel casters can be fixed so that they are movable in
only one direction. This significantly facilitates the directional stability, e.g., during train operation.
Casters made of stainless steel:
Stainless steel housing, plastic wheel, plate attachment
Coupling and drawbar:
For the connection of several Tray transport trolleys for train operation. The simple version is also
available in combination with casters that are movable in only one direction. The second option with
friction damping enables the directional stability during train operation even in tight bends.
Shelf for beverage containers with lengthwise or crosswise insertion
Stacking basket, stainless steel, plastic-coated, lengthwise insertion
Card holder for inserting into the gallery
Cold storage plates for appliances with passive cooling
Connection components for induction docking stations
(No embossed tilt protection is allowed when tray transport trolleys are to be used with inductive
docking stations.
Trays:
Tray transport trolleys are intended for the use of EN trays and GN trays. Suitable systems are; e.g
HUPFER
Induction crockery
Generally, all standard induction crockery can be used in combination with tray transport trolleys
and induction docking stations. Since the manufacturers sometimes use different coatings, the
power consumption is always dependent from the used crockery when the device setting is identi-
cal. When it deviates from the standard then a fine tuning between the device and the crockery is
always necessary. This fine tuning must be done by the manufacturer or the service technicians au-
thorized by the manufacturer.
On request, recommendations for induction crockery are made available. Isolating covers for the
4330080_A0
®
SDS trays.
Chapter 3
Page 13
Tray transport trolley
TTW/M