Meaning Leds; Setting The Clima Control Plus; Setting The Fan/Box; Custom Menu - TechGrow Clima Control Plus Manual Del Usario

7. Meaning LEDs

Light detected: light indicator (under PTK).
•
FAN: indicates that the fan is controlled.
•
OK: temperature is at desired level (+/- hysteresis).
•
HEAT: temperature is below setpoint - hysteresis.
•

8. Setting the Clima Control Plus

The Clima Control Plus is easy to operate with the Push-
and-Turn Knob (PTK).
When you start the Clima Control Plus for the first time,
you directly enter the BOX menu (see section 9). You
first set the BOX before you continue.
After that, you can access the various menus from the
main screen, which displays:
Line 1: current temperature (only displayed when a S-4
or Temp/RH Sensor is connected).
Line 2: current relative humidity level.
Line 3: current fan mode: automatic or manual ("Auto"
or "Man").
Line 4: current CO level.
2
TMP = 33.6 °C
RH = 66%
=> BOX = 90%
CO2 = 1112 PPM
By pressing the PTK you can access the main menu. An
arrow appears on the left side of the display, allowing
you to select the desired submenu.

9. Setting the fan/box

You access the box menu:
1. after starting the Clima Control Plus;
2. via the main screen.
Select "BOX" and press the PTK.
TMP = 33.6 °C
RH = 66%
=> BOX = 90%
CO2 = 1112 PPM
Select "Select box" and press the PTK.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
BOX A/M Auto
BOX min 10%
BOX max 90%
=> Select box
You access the box menu (fan menu):
Select box
=> Custom
Standard
By turning the PTK you choose standard "Standard" or
customisation "Custom".
If you choose "Standard", proceed with section 9.2.
If you choose the "Custom" option, select "Custom" and
press the PTK. The following screen is displayed.

9.1 Custom menu

Set box to desired
minimum speed.
Push to proceed.
■
The fan is not running or very slowly. Slowly turn the PTK
until the fan runs at 10% of its maximum speed. You set
this as the minimum speed.
Confirm by pressing the PTK. You will enter the next
screen:
Set box to desired
maximum speed.
Push to proceed.
■■■■■■■■■
Now, adjust the fan to the desired maximum speed,
which is 90% of the maximum capacity. First, let the fan
run at maximum speed and then slightly turn back the
PTK until the fan runs at 90% of its capacity.
Press the PTK to confirm.
20