Assembly - Weston 07-3101-W-A Manual De Instrucciones

4. Insert the Blade Assembly into the Lower
Housing, guiding the Drive Shaft into the
journals. Make sure the gears and the
blades of the Blade Assembly are properly
meshed together and resting in the journals
(FIGURE C). NOTE: The Tenderizer Blade
is a 2-piece set. The Jerky Slicer Blade is a
single piece (sold separately).
5. Position the Top Housing onto the
Lower Housing and line up the screw
holes.
6. Secure the Top Housing to the
Lower Housing using the 2 Housing
Thumbscrews. DO NOT OVERTIGHTEN!
FIGURE D
7. Insert the Left Comb and Right Comb
into the Top Housing. FIGURE D
NOTE: The Left Comb is marked with an
"L" on the upper portion of the Comb. The
Top Housing is marked with an "L Comb"
and "R Comb" to aid in Comb installation.
8. Install Handle onto the Blade Drive
Shaft. Secure the Handle to Drive Shaft
with the Handle Thumbscrew. FIGURE E
9. To change Blades, follow "Assembly
Instructions" as outlined.
NOTE: Periodically the gears on the
Blades need to be tightened. Use the
Allen Wrench to tighten the screw on the
gears.
Gears
Gears
Jerky blades sold separately
Top
Housing
Journals
Lower
Housing
Combs
Housing
Thumbscrews (2)
FIGURE C
Blade

Assembly

Drive Shaft
Journals
FIGURE D
FIGURE E
Drive Shaft
Handle
Thumbscrew
Handle
7