Remote Control Features
The hand held remote unit allows you to control all
operational aspects of your Portable 3 Season Home
Comfort Appliance from the convenience of your
favorite armchair. Here are some things you should
know about operating the unit with the hand held
remote.
Control Buttons
I/O: Power switch (On/Off).
Mode: Selects the operating mode (Auto/Cool/Dry-
Dehumidifier/Fan).
Note "Auto" mode is a pre-set factory mode inclusive
of a set operating temperature of 24C (75F). Under
AUTO mode the unit will alternate between
appropriate modes, COOL, DRY, FAN, to maintain
internal environment conditions at the pre-set 24C
(75F) temperature conditions.
Fan: Selects fan speed settings (Auto–LOW-MED-HIGH).
NOTE: The "Auto" fan speed setting is equivalent to
"Medium" fan speed.
+
Used to adjust (increase) temperature
settings.
(1° increments) on the Celsius scale.
(1° increments) on the Fahrenheit scale.
-
Used to adjust (decrease) temperature
settings.
(1° increments) on the Celsius scale.
(1° increments) on the Farenheight scale.
SWING: Used to activate the vertical louver
(oscillation) auto swing from side to side.
SLEEP: Used to activat the SLEEP program.
T-ON: Used to activate the TIMER-ON program.
T-OFF: Used to activate the TIMER-OFF program.
HOUR: Used to program the HOUR time.
MIN: Used to program the MINUTE time.
RESET: Used to re-set all remote control programs.
To operate the hand held remote control will require
two "AAA" Alkaline batteries (included ).
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to
program the main unit.
b) The main unit does not respond to a command
issued by the remote control.
Battery replacement:
1. Slide the rear cover on the remote in the direction
of the arow. Continue pulling (gently) until the
cover separates completely from the unit.
2. Insert (2) batteries (AAA) following the same
orientation (polarity) depicted inside the battery
chamber.(+/-)
3. Re-install rear cover.
4. If the remote control will not be used for extended
periods of time (vacations etc.), batteries should
be removed.
The remote operates within a range of 7 meters
(23 ft.) from the receiver located inside the main unit.
Any obstruction between the receiver and remote
may cause signal interference, limiting the ability to
program the main unit.
NOTE: The (illuminated) back-lit key pads on the
main unit control panel will not illuminate when
settings are made using the remote control unit.
(this is normal)
17