Counting Direction Selection; Inch And Metric Conversion; Decimal Point Setting Under Inch - Holzmann ED400FD Instrucciones De Servicio

Display the resolution of rotary encoder
After entering the resolution of the encoder, press
way as the X-axis.

25.4.3 Counting Direction Selection

The counting direction can be selected in the positive or negative direction (0 in the left window
indicates the positive counting direction of the window, 1 in the left window indicates the negative
counting direction of the window.)
To change the counting direction of the X axis, press
To change the counting direction of the Y axis, press
To change the counting direction of the Z axis, press
Press to go to "Inch and Metric Settings", press

25.4.4 Inch and Metric Conversion

When entering the Inch and Metric settings, press
After having made the desired setting, press
If you have selected "Metric", now press
If you have selected „Inch" press

25.4.5 Decimal Point Setting Under Inch

When the DRO is in inch mode, it supports 4 or 5 decimals. The factory setting is 5 decimals.
Setting can be changed. Setting way will be as follows:
5 decimals under inch
HOLZMANN MASCHINEN GmbH
DIGITAL POSITION INDICATOR (DITRON DL50 SERIES)
Linear Scale
to enter the decimal point setting.
www.holzmann-maschinen.at
Rotary encoder
Input the resolution of rotary encoder
to save. Y- and Z-axis are set in the same
.
.
.
to save and exit the parameter setting.
to select. Setting way will be as follows:
again, to enter the DRO mode setting.
to enter the DRO mode setting.
4 decimals under inch
65
ED400FD | ED400FDDIG