General Pipe Cleaners Spin-Drive 400 Instrucciones De Operación

Operating Instructions for
General Spin-Drive
For 2" to 4" lines (50mm – 100mm)
Your Spin-Drive is designed to give you years of trouble-free, profitable service. However, no
machine is better than its operator. We therefore suggest you read these instructions through
carefully before using your tool on the job. This will enable you to operate the Spin-Drive more
efficiently and more profitably. Failure to follow these instructions may cause personal injury to
operator and damage to the equipment.
Safety Instructions
Always wear safety glasses and rubber
soled, non-slip shoes. Use of this safety
equipment may prevent serious injury.
Only wear leather gloves. Never use any
other type of glove, such as cloth,
rubber, or coated gloves. Never grasp a
rotating cable with a rag. These items
could become wrapped around the cable
and cause serious injury.
Be careful when cleaning drains where
cleaning chemicals have been used.
Avoid direct contact with corrosive drain
cleaners. Drain cleaning chemicals can
cause serious burns, as well as damage
the cable.
Operating Instructions
1. Place Spin-Drive at a distance not greater
than two feet (60 cm) of drain opening.
2. Loosen thumbscrew on spout.
3. Pull cable from drum and insert into drain.
Push cable into pipe until resistance is met.
4. Pull one more foot of cable out of the drum
so that an arc is formed.
5. Tighten thumbscrew.
6. Use the turning handle to spin the drum
clockwise. Guide cable into the drain with
the other hand.
DO NOT FORCE THE CABLE.
Too much pressure can damage the cable.
Let it cut through stoppage at its own pace.
™
7. When all slack is out of cable, loosen
thumbscrew and repeat steps 4, 5, and 6
until drain is clear.
8. When job is complete, return cable to drum
while spinning it in the same clockwise
direction.
Hint: It is often helpful to run a stream of
water to wash away debris in line.
Model 400
Maintenance
To keep your tool operating smoothly, it is
essential that all bearings and cables be
lubricated. Oiling moving parts is particularly
important where machine comes in contact
with sand, grit and other abrasive material.
Model X500
CR-400/X500-OI-0710