Connecting Drain And Electrical - KENMORE ELITE 137412800 Instrucciones De Instalación

Installation Instructions

Connecting drain and electrical

1 Snap one end of the drain hose hanger (shipped in
washer drum) onto the drain hose. Continue wrapping it
around the hanger and snap it in place.
2 Place the hook end of the drain hose in the drain
opening. Secure the drain hose with the cable tie
(provided in the enclosure package) to the standpipe,
inlet hose, laundry tub, etc. so the hose does not pull out
from the force of the water.
IMPORTANT
Check to ensure the power is off at a circuit breaker/fuse
box before plugging the power cord into an outlet.
3 Plug the power cord into a grounded outlet.
Grounding type Grounding type
wall receptacl wa ll receptacle
Po Power cord with wer cord with
3-prong 3-prong gr grounded plug ounded plug
NOTE
After you plug in the washer the fi rst time, the washer will
power up on its own. It will take approximately one minute
for the LCD to perform initial boot up procedures.
4 Turn on the power at a circuit breaker/fuse box.
5 Carefully slide the washer to its fi nal position. Recheck
for level and rock corners for stability. Remove and
discard door tape.
6 Read the Use & Care Guide provided with the washer. It
contains valuable and helpful information that will save
you time and money.
7 See the next page about performing a brief, helpful
"Installation Cycle" for your new washer.
8 If you have any questions during initial operation, please
review the "Avoid Service Checklist" in your Use & Care
Guide before calling for service.
9 Place these instructions in a location near the washer for
future reference.
NOTE
A wiring diagram and technical data sheet are located under
the washer top panel, on top of the detergent dispenser
housing.
Do not, under Do not, under
an any cir y circumstances, cumstances,
cut, remo cut, remove ve,
or bypass th or b ypass the
gr grounding pr ounding prong. ong.
CABLE TIE
10