KENMORE ELITE 137412800 Instrucciones De Instalación página 11

Installation Instructions - Performing Installation Cycle
With your washer in fi nal location, perform an Installation Cycle to assist in proper installation.
If your washer has this console:
1. Empty washer's drum and close door.
2. After you plug in the washer the fi rst time: wake up the washer by pressing the
cycle one up from lower right position (1), and within 10 seconds, immediately and simultaneously press and hold both
the far right options button above the LED (2a) and the far right settings button under the LED (2b) for 5 seconds, or
until the LED display changes.
3. The LED window will display
The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window may
display
an action such as
("Call Service" - 1-800-4-MY-HOME), review the installation steps and make the necessary corrections
before you attempt to use the washer.
4. Your washer will exit the
NOTE
Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the
washer through a washing cycle, press the POWER button to put the unit to sleep and then rewake it
immediately with the POWER button to continue the normal operating mode.
Use & Care Guide and enjoy your new premium washer!
5. Please read the
If your washer has this console:
1. After you plug in the washer the fi rst time, the washer will power up on its own. Then follow the prompts on the touch
screen LCD, including language selection.
2. The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window may
display INSTALL PASS!, meaning your new washer is properly installed and ready for use. If it prompts an action such as
NO WATER, CHECK HOSES or CALL SERVICE - 1-800-4-MY-HOME, review the installation steps and make the neces-
sary corrections before you attempt to use the washer.
3. Your washer will exit the
NOTE
Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the
washer through a washing cycle, press the POWER button to put the unit to sleep and then rewake it
immediately with the POWER button to continue the normal operating mode.
4. Please read the Use & Care Guide and enjoy your new premium washer!
("Install") and show estimated time of cycle completion. Press the START button (4).
("Install Pass"), meaning your new washer is properly installed and ready for use. If it prompts
("No Water"),
Installation Cycle and return to normal operation the next time you wake it up.
Installation Cycle and return to normal operation the next time you wake it up.
1
POWER button (3), rotate cycle knob to
("Flip Hoses" - Reverse Hot and Cold Water Supply), or
11
2a
2b
3 4