Important - Nogueira PTN-1000 G3 Manual De Instrucciones

4. Preparation
Fit the bottom (D) into the 2 pints (E) of
3.
the tensioner.
Fit the two gears (F).
4.
NOTE!
The bolts, nuts, washers and shims are
in the kit supplied with the head.
Fit the sprocket (J) - 16 teeth.
5.
Fit the sprocket (K) - 25 teeth.
6.
Using a ruler, check if the sprockets are
7.
aligned.
If necessary, adjust the height of the
8.
sprocket (J) by changing the number of
shims under it.

IMPORTANT!

The 3 sprockets must work perfectly
aligned, otherwise the roller chain
will be damaged.
After aligning the sprockets, secure them
9.
to the shaft with the bolts and washers (L).
Fit the roller chain (N).
10.
L = Hex Bolt M8 X 20 (01 pc)
L = Flat washer Ø43 mm x Ø12 mm x 6.35
mm (01 pc)
Adjust the chain using the tensioner (B).
11.
Loosen bolt (R) and push the tensioner
(B) against the chain, eliminating slack.
Retighten bolt (R).
44
Instructions Manual