Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS (CONTINUED)
INSPECT THE BEDKNIFE
Inspect the bedknife for damage (cracks, warping, bushing wear, excessive bedknife wear).
Replace or repair if necessary, see the mowing unit manual for additional information.
Thoroughly clean the bedknife prior to grinding. Replace any loose rivets, and tighten any loose
screws.
MOUNTING THE BEDKNIFE ON THE BEDKNIFE SUPPORT
1. Use the center cone to mount the bedknife. Move the Center supports to the width needed
to accept the bedknife. Place the bedknife in the fixed center cone and turn the knob on the
adjustable center cone until there is no side to side free play.
!
THE CENTER SHOULD
NOT LOAD THE BEDBAR
IN ANY DIRECTION. THE
CENTER CONE SHOULD
BE TIGHTENED ONLY
ENOUGH TO HOLD THE
BEDBAR RIGID.
Use this knob to tighten the
bedknife between the
centers.
Middle bedknife support.
Use these knobs to move
the center supports back
and forth on the trunnion bar.
2. Use the center locking knob to secure the adjustable center cone in place.
!
IF THE LOCK KNOB IS
NOT TIGHT, THE CENTER
CONE COULD LOOSEN.
THIS WILL RESULT IN A
POOR GRIND.
16
FIG. 8
FIG. 9
FIG. 10
Publicidad
