Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
1. The lead screw/threaded rod should have zero play when reversing the hand wheel. Check to
assure that the hand wheel and top nut are locked together. Then adjust for play with the nut
under the support. Next secure the adjustment by locking the two nuts together, under the
support.
2. There are set screws in the back of the top cap to secure it to the column. These set screws
must be tight.
3. There are set screws in the back of the motor mounts. The set screws have nylon pads under
them to prevent damage to the column. The set screws in the motor mount should be
adjusted so that there is zero play, but allow the motor mount to slide freely up and down the
column.
4. The screws that hold the tube of the guard to the top of the guard should be adjusted so that the
spring washers hold the guard in place, yet allow the guard to be rotated as the grinding head is
moved toward or away from the bedknife.
1
4
Adjustments
The guard must be in place during
the grinding process.
11
2
3
Publicidad
